ASTM G103 - 97(2011) Standard Practice for Evaluating Stress-Corrosion Cracking Resistance of Low Copper 7XXX Series Al-Zn-Mg-Cu Alloys in Boiling 6% Sodium Chloride Solution


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    G30 Standard Practice for Making and Using U-Bend Stress-Corrosion Test Specimens


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    B580 Specification for Anodic Oxide Coatings on Aluminum

    D1193 Specification for Reagent Water

    G30 Practice for Making and Using U-Bend Stress-Corrosion Test Specimens

    G38 Practice for Making and Using C-Ring Stress-Corrosion Test Specimens

    G39 Practice for Preparation and Use of Bent-Beam Stress-Corrosion Test Specimens

    G44 Practice for Exposure of Metals and Alloys by Alternate Immersion in Neutral 3.5 % Sodium Chloride Solution

    G49 Practice for Preparation and Use of Direct Tension Stress-Corrosion Test Specimens

    G58 Practice for Preparation of Stress-Corrosion Test Specimens for Weldments