ASTM F788 - 13 Standard Specification for Surface Discontinuities of Bolts, Screws, and Studs, Inch and Metric Series


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    F879M Standard Specification for Stainless Steel Socket Button and Flat Countersunk Head Cap Screws (Metric)

    F879 Standard Specification for Stainless Steel Socket Button and Flat Countersunk Head Cap Screws

    F880M Standard Specification for Stainless Steel Socket Set Screws (Metric)

    F1941/F1941M Standard Specification for Electrodeposited Coatings on Mechanical Fasteners, Inch and Metric

    F3019/F3019M Standard Specification for Chromium Free Zinc-Flake Composite, with or without Integral Lubricant, Corrosion Protective Coatings for Fasteners

    F3043 Standard Specification for “Twist Off” Type Tension Control Structural Bolt/Nut/Washer Assemblies, Alloy Steel, Heat Treated, 200 ksi Minimum Tensile Strength

    F3111 Standard Specification for Heavy Hex Structural Bolt/Nut/Washer Assemblies, Alloy Steel, Heat Treated, 200 ksi Minimum Tensile Strength

    F3125/F3125M Standard Specification for High Strength Structural Bolts, Steel and Alloy Steel, Heat Treated, 120 ksi (830 MPa) and 150 ksi (1040 MPa) Minimum Tensile Strength, Inch and Metric Dimensions

    F3148 Standard Specification for High Strength Structural Bolt Assemblies, Steel and Alloy Steel, Heat Treated, 144ksi Minimum Tensile Strength, Inch Dimensions


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    E340 Test Method for Macroetching Metals and Alloys

    F1470 Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection

    F1789 Terminology for F16 Mechanical Fasteners