ASTM F714 - 13 Standard Specification for Polyethylene (PE) Plastic Pipe (DR-PR) Based on Outside Diameter


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    F412 Standard Terminology Relating to Plastic Piping Systems

    F585 Standard Guide for Insertion of Flexible Polyethylene Pipe Into Existing Sewers

    F1055 Standard Specification for Electrofusion Type Polyethylene Fittings for Outside Diameter Controlled Polyethylene and Crosslinked Polyethylene (PEX) Pipe and Tubing

    F1759 Standard Practice for Design of High-Density Polyethylene (HDPE) Manholes for Subsurface Applications

    F1901 Standard Specification for Polyethylene (PE) Pipe and Fittings for Roof Drain Systems

    F1962 Standard Guide for Use of Maxi-Horizontal Directional Drilling for Placement of Polyethylene Pipe or Conduit Under Obstacles, Including River Crossings

    F2021 Standard Guide for Design and Installation of Plastic Siphonic Roof Drainage Systems

    F2165 Standard Specification for Flexible Pre-Insulated Piping

    F2206 Standard Specification for Fabricated Fittings of Butt-Fused Polyethylene (PE) Plastic Pipe, Fittings, Sheet Stock, Plate Stock, or Block Stock

    F2620 Standard Practice for Heat Fusion Joining of Polyethylene Pipe and Fittings

    F2649 Standard Specification for Corrugated High Density Polyethylene (HDPE) Grease Interceptor Tanks

    F2737 Standard Specification for Corrugated High Density Polyethylene (HDPE) Water Quality Units

    F2880 Standard Specification for Lap-Joint Type Flange Adapters for Polyethylene Pressure Pipe in Nominal Pipe Sizes ¾ in. to 65 in.


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    D1238 Test Method for Melt Flow Rates of Thermoplastics by Extrusion Plastometer

    D1598 Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure

    D1599 Test Method for Resistance to Short-Time Hydraulic Pressure of Plastic Pipe, Tubing, and Fittings

    D1600 Terminology for Abbreviated Terms Relating to Plastics

    D2122 Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings

    D2290 Test Method for Apparent Hoop Tensile Strength of Plastic or Reinforced Plastic Pipe by Split Disk Method

    D2321 Practice for Underground Installation of Thermoplastic Pipe for Sewers and Other Gravity-Flow Applications

    D2412 Test Method for Determination of External Loading Characteristics of Plastic Pipe by Parallel-Plate Loading

    D2837 Test Method for Obtaining Hydrostatic Design Basis for Thermoplastic Pipe Materials or Pressure Design Basis for Thermoplastic Pipe Products

    D3350 Specification for Polyethylene Plastics Pipe and Fittings Materials

    F412 Terminology Relating to Plastic Piping Systems

    F585 Practice for Insertion of Flexible Polyethylene Pipe Into Existing Sewers