ASTM F2329 - 11 Standard Specification for Zinc Coating, Hot-Dip, Requirements for Application to Carbon and Alloy Steel Bolts, Screws, Washers, Nuts, and Special Threaded FastenersCiting ASTM Standards
Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.
A193/A193M Standard Specification for Alloy-Steel and Stainless Steel Bolting for High Temperature or High Pressure Service and Other Special Purpose Applications A194/A194M Standard Specification for Carbon and Alloy Steel Nuts for Bolts for High Pressure or High Temperature Service, or Both A307 Standard Specification for Carbon Steel Bolts, Studs, and Threaded Rod 60 000 PSI Tensile Strength A325 Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength A354 Standard Specification for Quenched and Tempered Alloy Steel Bolts, Studs, and Other Externally Threaded Fasteners A394 Standard Specification for Steel Transmission Tower Bolts, Zinc-Coated and Bare A449 Standard Specification for Hex Cap Screws, Bolts and Studs, Steel, Heat Treated, 120/105/90 ksi Minimum Tensile Strength, General Use A563 Standard Specification for Carbon and Alloy Steel Nuts A1059/A1059M Standard Specification for Zinc Alloy Thermo-Diffusion Coatings (TDC) on Steel Fasteners, Hardware, and Other Products F436 Standard Specification for Hardened Steel Washers F844 Standard Specification for Washers, Steel, Plain (Flat), Unhardened for General Use F1554 Standard Specification for Anchor Bolts, Steel, 36, 55, and 105-ksi Yield Strength Referenced ASTM Standards
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
| ||