ASTM F2019 - 11 Standard Practice for Rehabilitation of Existing Pipelines and Conduits by the Pulled in Place Installation of Glass Reinforced Plastic (GRP) Cured-in-Place Thermosetting Resin Pipe (CIPP)


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    D5813 Standard Specification for Cured-In-Place Thermosetting Resin Sewer Piping Systems


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    D543 Practices for Evaluating the Resistance of Plastics to Chemical Reagents

    D578 Specification for Glass Fiber Strands

    D638 Test Method for Tensile Properties of Plastics

    D790 Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials

    D1600 Terminology for Abbreviated Terms Relating to Plastics

    D3039/D3039M Test Method for Tensile Properties of Polymer Matrix Composite Materials

    D3567 Practice for Determining Dimensions of Fiberglass (Glass-Fiber-Reinforced Thermosetting Resin) Pipe and Fittings

    D5813 Specification for Cured-In-Place Thermosetting Resin Sewer Piping Systems

    F412 Terminology Relating to Plastic Piping Systems

    F1216 Practice for Rehabilitation of Existing Pipelines and Conduits by the Inversion and Curing of a Resin-Impregnated Tube

    F1417 Practice for Installation Acceptance of Plastic Non-pressure Sewer Lines Using Low-Pressure Air