ASTM F1962 - 11 Standard Guide for Use of Maxi-Horizontal Directional Drilling for Placement of Polyethylene Pipe or Conduit Under Obstacles, Including River Crossings


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    There are currently no referencing documents for this standard.


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    D420 Guide to Site Characterization for Engineering Design and Construction Purposes

    D422 Test Method for Particle-Size Analysis of Soils

    D1586 Test Method for Penetration Test (SPT) and Split-Barrel Sampling of Soils

    D1587 Practice for Thin-Walled Tube Sampling of Soils for Geotechnical Purposes

    D2113 Practice for Rock Core Drilling and Sampling of Rock for Site Investigation

    D2166 Test Method for Unconfined Compressive Strength of Cohesive Soil

    D2435 Test Methods for One-Dimensional Consolidation Properties of Soils Using Incremental Loading

    D2447 Specification for Polyethylene (PE) Plastic Pipe, Schedules 40 and 80, Based on Outside Diameter

    D2513 Specification for Polyethylene (PE) Gas Pressure Pipe, Tubing, and Fittings

    D2850 Test Method for Unconsolidated-Undrained Triaxial Compression Test on Cohesive Soils

    D3035 Specification for Polyethylene (PE) Plastic Pipe (DR-PR) Based on Controlled Outside Diameter

    D4186 Test Method for One-Dimensional Consolidation Properties of Saturated Cohesive Soils Using Controlled-Strain Loading

    D4220 Practices for Preserving and Transporting Soil Samples

    D4318 Test Methods for Liquid Limit, Plastic Limit, and Plasticity Index of Soils

    D4767 Test Method for Consolidated Undrained Triaxial Compression Test for Cohesive Soils

    D5084 Test Methods for Measurement of Hydraulic Conductivity of Saturated Porous Materials Using a Flexible Wall Permeameter

    F714 Specification for Polyethylene (PE) Plastic Pipe (DR-PR) Based on Outside Diameter

    F1804 Practice for Determining Allowable Tensile Load for Polyethylene (PE) Gas Pipe During Pull-In Installation

    F2620 Practice for Heat Fusion Joining of Polyethylene Pipe and Fittings