ASTM E2785 - 11 Standard Test Method for Exposure of Firestop Materials to Severe Environmental Conditions


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    There are currently no referencing documents for this standard.


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    C177 Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded-Hot-Plate Apparatus

    C1442 Practice for Conducting Tests on Sealants Using Artificial Weathering Apparatus

    D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension

    D870 Practice for Testing Water Resistance of Coatings Using Water Immersion

    D2041 Test Method for Theoretical Maximum Specific Gravity and Density of Bituminous Paving Mixtures

    D3045 Practice for Heat Aging of Plastics Without Load

    D3850 Test Method for Rapid Thermal Degradation of Solid Electrical Insulating Materials By Thermogravimetric Method (TGA)

    D4434 Specification for Poly(Vinyl Chloride) Sheet Roofing

    D4637 Specification for EPDM Sheet Used In Single-Ply Roof Membrane

    D4714 Test Method for Determination of Effect of Moist Heat (50 % Relative Humidity and 90C) on Properties of Paper and Board

    D5510 Practice for Heat Aging of Oxidatively Degradable Plastics

    D5893 Specification for Cold Applied, Single Component, Chemically Curing Silicone Joint Sealant for Portland Cement Concrete Pavements

    D6083 Specification for Liquid Applied Acrylic Coating Used in Roofing

    D6754 Specification for Ketone Ethylene Ester Based Sheet Roofing

    D6878 Specification for Thermoplastic Polyolefin Based Sheet Roofing

    D6947 Specification for Liquid Applied Moisture Cured Polyurethane Coating Used in Spray Polyurethane Foam Roofing System

    E84 Test Method for Surface Burning Characteristics of Building Materials

    E119 Test Methods for Fire Tests of Building Construction and Materials

    E145 Specification for Gravity-Convection and Forced-Ventilation Ovens

    E176 Terminology of Fire Standards

    E473 Terminology Relating to Thermal Analysis and Rheology

    E631 Terminology of Building Constructions

    E814 Test Method for Fire Tests of Penetration Firestop Systems

    F495 Test Method for Weight Loss of Gasket Materials Upon Exposure to Elevated Temperatures

    G151 Practice for Exposing Nonmetallic Materials in Accelerated Test Devices that Use Laboratory Light Sources

    G155 Practice for Operating Xenon Arc Light Apparatus for Exposure of Non-Metallic Materials