ASTM E2579 - 15 Standard Practice for Specimen Preparation and Mounting of Wood Products to Assess Surface Burning Characteristics


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    E84 Standard Test Method for Surface Burning Characteristics of Building Materials

    E2404 Standard Practice for Specimen Preparation and Mounting of Textile, Paper or Polymeric (Including Vinyl) and Wood Wall or Ceiling Coverings, Facings and Veneers, to Assess Surface Burning Characteristics


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    C1396/C1396M Specification for Gypsum Board

    D9 Terminology Relating to Wood and Wood-Based Products

    D1038 Terminology Relating to Veneer and Plywood

    D1554 Terminology Relating to Wood-Base Fiber and Particle Panel Materials

    D4442 Test Methods for Direct Moisture Content Measurement of Wood and Wood-Base Materials

    D4444 Test Method for Laboratory Standardization and Calibration of Hand-Held Moisture Meters

    D7438 Practice for Field Calibration and Application of Hand-Held Moisture Meters

    E84 Test Method for Surface Burning Characteristics of Building Materials

    E176 Terminology of Fire Standards

    E2404 Practice for Specimen Preparation and Mounting of Textile, Paper or Polymeric (Including Vinyl) Wall or Ceiling Coverings, and of Facings and Wood Veneers Intended to be Applied on Site Over a Wood Substrate, to Assess Surface Burning Characteristics