ASTM E2251 - 14 Standard Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    C359 Standard Test Method for Early Stiffening of Hydraulic Cement (Mortar Method)

    C403/C403M Standard Test Method for Time of Setting of Concrete Mixtures by Penetration Resistance

    C782 Standard Test Method for Softness of Preformed Tape Sealants

    D5/D5M Standard Test Method for Penetration of Bituminous Materials

    D914 Standard Test Methods for Ethylcellulose

    D1045 Standard Test Methods for Sampling and Testing Plasticizers Used in Plastics

    D1074 Standard Test Method for Compressive Strength of Bituminous Mixtures

    D1075 Standard Test Method for Effect of Water on Compressive Strength of Compacted Bituminous Mixtures

    D1125 Standard Test Methods for Electrical Conductivity and Resistivity of Water

    D1321 Standard Test Method for Needle Penetration of Petroleum Waxes

    D1429 Standard Test Methods for Specific Gravity of Water and Brine

    D1795 Standard Test Method for Intrinsic Viscosity of Cellulose

    D2111 Standard Test Methods for Specific Gravity and Density of Halogenated Organic Solvents and Their Admixtures

    D2251 Standard Test Method for Metal Corrosion by Halogenated Organic Solvents and Their Admixtures

    D2364 Standard Test Methods for Hydroxyethylcellulose

    D2726/D2726M Standard Test Method for Bulk Specific Gravity and Density of Non-Absorptive Compacted Bituminous Mixtures

    D2746 Standard Test Method for Staining Tendency of Asphalt (Stain Index)

    D2838 Standard Test Method for Shrink Tension and Orientation Release Stress of Plastic Film and Thin Sheeting

    D2913 Standard Test Method for Mercaptan Content of the Atmosphere

    D3012 Standard Test Method for Thermal-Oxidative Stability of Polypropylene Using a Specimen Rotator Within an Oven

    D3154 Standard Test Method for Average Velocity in a Duct (Pitot Tube Method)

    D3195/D3195M Standard Practice for Rotameter Calibration

    D3642 Standard Test Method for Softening Point of Certain Alkali-Soluble Resins

    D3685/D3685M Standard Test Methods for Sampling and Determination of Particulate Matter in Stack Gases

    D4171 Standard Specification for Fuel System Icing Inhibitors

    D4532 Standard Test Method for Respirable Dust in Workplace Atmospheres Using Cyclone Samplers

    D4659 Standard Test Methods for Polyurethane Raw Materials: Determination of Specific Gravity of Isocyanates

    D4669 Standard Test Method for Polyurethane Raw Materials: Determination of Specific Gravity of Polyols

    D4943 Standard Test Method for Shrinkage Factors of Soils by the Wax Method

    D5006 Standard Test Method for Measurement of Fuel System Icing Inhibitors (Ether Type) in Aviation Fuels

    D5298 Standard Test Method for Measurement of Soil Potential (Suction) Using Filter Paper

    D5438 Standard Practice for Collection of Floor Dust for Chemical Analysis

    D5478 Standard Test Methods for Viscosity of Materials by a Falling Needle Viscometer

    D5801 Standard Test Method for Toughness and Tenacity of Bituminous Materials

    D5865 Standard Test Method for Gross Calorific Value of Coal and Coke

    D5869 Standard Practice for Dark Oven Heat Exposure of Roofing and Waterproofing Materials

    D6084/D6084M Standard Test Method for Elastic Recovery of Bituminous Materials by Ductilometer

    D6209 Standard Test Method for Determination of Gaseous and Particulate Polycyclic Aromatic Hydrocarbons in Ambient Air (Collection on Sorbent-Backed Filters with Gas Chromatographic/Mass Spectrometric Analysis)

    D6331 Standard Test Method for Determination of Mass Concentration of Particulate Matter from Stationary Sources at Low Concentrations (Manual Gravimetric Method)

    D6539 Standard Test Method for Measurement of the Permeability of Unsaturated Porous Materials by Flowing Air

    D6572 Standard Test Methods for Determining Dispersive Characteristics of Clayey Soils by the Crumb Test

    D7263 Standard Test Methods for Laboratory Determination of Density (Unit Weight) of Soil Specimens

    D7577 Standard Test Method for Determining the Accelerated Iron Corrosion Rating of Denatured Fuel Ethanol and Ethanol Fuel Blends

    E1 Standard Specification for ASTM Liquid-in-Glass Thermometers

    E100 Standard Specification for ASTM Hydrometers

    E126 Standard Test Method for Inspection, Calibration, and Verification of ASTM Hydrometers

    E344 Terminology Relating to Thermometry and Hydrometry

    E644 Standard Test Methods for Testing Industrial Resistance Thermometers

    F390 Standard Test Method for Sheet Resistance of Thin Metallic Films With a Collinear Four-Probe Array

    F483 Standard Practice for Total Immersion Corrosion Test for Aircraft Maintenance Chemicals

    F558 Standard Test Method for Measuring Air Performance Characteristics of Vacuum Cleaners

    F820 Standard Test Method for Measuring Air Performance Characteristics of Central Vacuum Cleaning Systems

    F1914 Standard Test Methods for Short-Term Indentation and Residual Indentation of Resilient Floor Covering

    F2105 Standard Test Method for Measuring Air Performance Characteristics of Vacuum Cleaner Motor/Fan Systems

    G42 Standard Test Method for Cathodic Disbonding of Pipeline Coatings Subjected to Elevated Temperatures


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    E1 Specification for ASTM Liquid-in-Glass Thermometers

    E77 Test Method for Inspection and Verification of Thermometers

    E344 Terminology Relating to Thermometry and Hydrometry

    E563 Practice for Preparation and Use of an Ice-Point Bath as a Reference Temperature