ASTM E145 - 94(2011) Standard Specification for Gravity-Convection and Forced-Ventilation Ovens


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    C765 Standard Test Method for Low-Temperature Flexibility of Preformed Tape Sealants

    C771 Standard Test Method for Weight Loss After Heat Aging of Preformed Tape Sealants

    C772 Standard Test Method for Oil Migration or Plasticizer Bleed-Out of Preformed Tape Sealants

    C910 Standard Test Method for Bond and Cohesion of One-Part Elastomeric Solvent Release-Type Sealants

    D6/D6M Standard Test Method for Loss on Heating of Oil and Asphaltic Compounds

    D244 Standard Test Methods and Practices for Emulsified Asphalts

    D350 Standard Test Methods for Flexible Treated Sleeving Used for Electrical Insulation

    D395 Standard Test Methods for Rubber Property—Compression Set

    D471 Standard Test Method for Rubber Property—Effect of Liquids

    D558 Standard Test Methods for Moisture-Density (Unit Weight) Relations of Soil-Cement Mixtures

    D573 Standard Test Method for Rubber—Deterioration in an Air Oven

    D806 Standard Test Method for Cement Content of Hardened Soil-Cement Mixtures

    D925 Standard Test Methods for Rubber Property—Staining of Surfaces (Contact, Migration, and Diffusion)

    D926 Standard Test Method for Rubber Property—Plasticity and Recovery (Parallel Plate Method)

    D1140 Standard Test Methods for Determining the Amount of Material Finer than 75-μm (No. 200) Sieve in Soils by Washing

    D1754/D1754M Standard Test Method for Effects of Heat and Air on Asphaltic Materials (Thin-Film Oven Test)

    D1766 Standard Test Method for Rubber Chemicals - Solubility

    D1917 Standard Test Methods for Rubber Property—Shrinkage of Raw and Compounded Hot-Polymerized Styrene-Butadiene Rubber (SBR)

    D1934 Standard Test Method for Oxidative Aging of Electrical Insulating Petroleum Oils by Open-Beaker Method

    D2060 Standard Test Methods for Measuring Zipper Dimensions

    D2067 Standard Test Method for Coarse Particles in Printing Ink Dispersions

    D2168 Standard Test Methods for Calibration of Laboratory Mechanical-Rammer Soil Compactors

    D2216 Standard Test Methods for Laboratory Determination of Water (Moisture) Content of Soil and Rock by Mass

    D2259 Standard Test Method for Shrinkage of Yarns

    D2369 Standard Test Method for Volatile Content of Coatings

    D2383 Standard Practice for Testing Plasticizer Compatibility in Poly(Vinyl Chloride) (PVC) Compounds Under Humid Conditions

    D2561 Standard Test Method for Environmental Stress-Crack Resistance of Blow-Molded Polyethylene Containers

    D2684 Standard Test Method for Permeability of Thermoplastic Containers to Packaged Reagents or Proprietary Products

    D2973 Standard Test Method for Total Nitrogen in Peat Materials

    D2974 Standard Test Methods for Moisture, Ash, and Organic Matter of Peat and Other Organic Soils

    D3030 Standard Test Method for Volatile Matter (Including Water) of Vinyl Chloride Resins

    D3045 Standard Practice for Heat Aging of Plastics Without Load

    D3182 Standard Practice for Rubber—Materials, Equipment, and Procedures for Mixing Standard Compounds and Preparing Standard Vulcanized Sheets

    D3191 Standard Test Methods for Carbon Black in SBR (Styrene-Butadiene Rubber)—Recipe and Evaluation Procedures

    D3194 Standard Test Method for Rubber From Natural Sources-Plasticity Retention Index (PRI)

    D3314 Standard Test Method for Rubber—Chemical Analysis for Polystyrene Blocks In SBR (Styrene-Butadiene Rubber) and Styrene-Reinforced Latices

    D3707 Standard Test Method for Storage Stability of Water-in-Oil Emulsions by the Oven Test Method

    D3769 Standard Test Method for Microcellular Urethanes--High Temperature Sag

    D3791/D3791M Standard Practice for Evaluating the Effects of Heat on Asphalts

    D3854 Standard Test Method for Rubber Thread-Resistance to Dry Heat

    D3855 Standard Test Method for Rubber Thread-Deterioration Due to Standard Washing Solution Treatment

    D3910 Standard Practices for Design, Testing, and Construction of Slurry Seal

    D4215 Standard Specification for Cold-Mixed, Cold-Laid Bituminous Paving Mixtures

    D4221 Standard Test Method for Dispersive Characteristics of Clay Soil by Double Hydrometer

    D4350 Standard Test Method for Corrosivity Index of Plastics and Fillers

    D4373 Standard Test Method for Rapid Determination of Carbonate Content of Soils

    D4498 Standard Test Method for Heat-Fail Temperature in Shear of Hot Melt Adhesives

    D4570 Standard Test Method for Rubber Chemicals—Determination of Particle Size of Sulfur by Sieving (Dry)

    D4713 Standard Test Methods for Nonvolatile Content of Heatset and Liquid Printing Ink Systems

    D4829 Standard Test Method for Expansion Index of Soils

    D5087 Standard Test Method for Determining Amount of Volatile Organic Compound (VOC) Released from Solventborne Automotive Coatings and Available for Removal in a VOC Control Device (Abatement)

    D5095 Standard Test Method for Determination of the Nonvolatile Content in Silanes, Siloxanes and Silane-Siloxane Blends Used in Masonry Water Repellent Treatments

    D5200 Standard Test Method for Determination of Weight Percent Volatile Content of Solvent-Borne Paints in Aerosol Cans

    D5240/D5240M Standard Test Method for Evaluation of Durability of Rock for Erosion Control Using Sodium Sulfate or Magnesium Sulfate

    D5268 Standard Specification for Topsoil Used for Landscaping Purposes

    D5312/D5312M Standard Test Method for Evaluation of Durability of Rock for Erosion Control Under Freezing and Thawing Conditions

    D5329 Standard Test Methods for Sealants and Fillers, Hot-Applied, for Joints and Cracks in Asphaltic and Portland Cement Concrete Pavements

    D5403 Standard Test Methods for Volatile Content of Radiation Curable Materials

    D5419 Standard Test Method for Environmental Stress Crack Resistance (ESCR) of Threaded Plastic Closures

    D5427 Standard Practice for Accelerated Aging of Inflatable Restraint Fabrics

    D5668 Standard Test Methods for Rubber From Synthetic Sources—Volatile Matter

    D5721 Standard Practice for Air-Oven Aging of Polyolefin Geomembranes

    D5856 Standard Test Method for Measurement of Hydraulic Conductivity of Porous Material Using a Rigid-Wall, Compaction-Mold Permeameter

    D5860 Standard Test Method for Evaluation of the Effect of Water Repellent Treatments on Freeze-Thaw Resistance of Hydraulic Cement Mortar Specimens

    D5869 Standard Practice for Dark Oven Heat Exposure of Roofing and Waterproofing Materials

    D5887 Standard Test Method for Measurement of Index Flux Through Saturated Geosynthetic Clay Liner Specimens Using a Flexible Wall Permeameter

    D5890 Standard Test Method for Swell Index of Clay Mineral Component of Geosynthetic Clay Liners

    D5993 Standard Test Method for Measuring Mass Per Unit of Geosynthetic Clay Liners

    D6147 Standard Test Method for Vulcanized Rubber and Thermoplastic Elastomer—Determination of Force Decay (Stress Relaxation) in Compression

    D6150 Standard Test Method for Estimating Processing Losses of Plastisols and Organosols Due to Volatility

    D6189 Standard Practice for Evaluating the Efficiency of Chemical Removers for Organic Coatings

    D6266 Test Method for Determining the Amount of Volatile Organic Compound (VOC) Released From Waterborne Automotive Coatings and Available for Removal in a VOC Control Device (Abatement)

    D6276 Standard Test Method for Using pH to Estimate the Soil-Lime Proportion Requirement for Soil Stabilization

    D6372 Standard Practice for Design, Testing, and Construction of Micro-Surfacing

    D6419 Standard Test Method for Volatile Content of Sheet-Fed and Coldset Web Offset Printing Inks

    D6473 Standard Test Method for Specific Gravity and Absorption of Rock For Erosion Control

    D6475 Standard Test Method for Measuring Mass Per Unit Area of Erosion Control Blankets

    D6489 Standard Test Method for Determining the Water Absorption of Hardened Concrete Treated With a Water Repellent Coating

    D6511/D6511M Standard Test Methods for Solvent Bearing Bituminous Compounds

    D6532 Standard Test Method for Evaluation of the Effect of Clear Water Repellent Treatments on Water Absorption of Hydraulic Cement Mortar Specimens

    D6539 Standard Test Method for Measurement of the Permeability of Unsaturated Porous Materials by Flowing Air

    D6766 Standard Test Method for Evaluation of Hydraulic Properties of Geosynthetic Clay Liners Permeated with Potentially Incompatible Aqueous Solutions

    D7382 Standard Test Methods for Determination of Maximum Dry Unit Weight and Water Content Range for Effective Compaction of Granular Soils Using a Vibrating Hammer

    D7444 Standard Practice for Heat and Humidity Aging of Oxidatively Degradable Plastics

    D7503 Standard Test Method for Measuring the Exchange Complex and Cation Exchange Capacity of Inorganic Fine-Grained Soils

    D7626 Standard Test Methods for Determining the Organic Treat Loading of Organophilic Clay

    D7767 Standard Test Method to Measure Volatiles from Radiation Curable Acrylate Monomers, Oligomers, and Blends and Thin Coatings Made from Them

    E359 Standard Test Methods for Analysis of Soda Ash (Sodium Carbonate)

    E2785 Standard Test Method for Exposure of Firestop Materials to Severe Environmental Conditions

    F2524 Standard Practice for Determination of Volatile Content for Formed-in-Place Gaskets (FIPG) Silicone Adhesives and Sealants for Transportation Applications

    F2894 Standard Test Method for Evaluation of Materials, Protective Clothing and Equipment for Heat Resistance Using a Hot Air Circulating Oven


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    There are currently no reference documents for this standard.