ASTM D892 - 13 Standard Test Method for Foaming Characteristics of Lubricating Oils


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    D4293 Standard Specification for Phosphate Ester Based Fluids for Turbine Lubrication

    D4304 Standard Specification for Mineral and Synthetic Lubricating Oil Used in Steam or Gas Turbines

    D4378 Standard Practice for In-Service Monitoring of Mineral Turbine Oils for Steam, Gas, and Combined Cycle Turbines

    D4485 Standard Specification for Performance of Active API Service Category Engine Oils

    D5760 Standard Specification for Performance of Manual Transmission Gear Lubricants

    D6082 Standard Test Method for High Temperature Foaming Characteristics of Lubricating Oils

    D6158 Standard Specification for Mineral Hydraulic Oils

    D6224 Standard Practice for In-Service Monitoring of Lubricating Oil for Auxiliary Power Plant Equipment

    D6666 Standard Guide for Evaluation of Aqueous Polymer Quenchants

    D6813 Standard Guide for Performance Evaluation of Hydraulic Fluids for Piston Pumps

    D6894 Standard Test Method for Evaluation of Aeration Resistance of Engine Oils in Direct-Injected Turbocharged Automotive Diesel Engine

    D7044 Standard Specification for Biodegradable Fire Resistant Hydraulic Fluids

    D7155 Standard Practice for Evaluating Compatibility of Mixtures of Turbine Lubricating Oils

    D7450 Standard Specification for Performance of Rear Axle Gear Lubricants Intended for API Category GL-5 Service

    D7578 Standard Guide for Calibration Requirements for Elemental Analysis of Petroleum Products and Lubricants

    D7752 Standard Practice for Evaluating Compatibility of Mixtures of Hydraulic Fluids


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    D445 Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)

    D6082 Test Method for High Temperature Foaming Characteristics of Lubricating Oils

    E1 Specification for ASTM Liquid-in-Glass Thermometers

    E128 Test Method for Maximum Pore Diameter and Permeability of Rigid Porous Filters for Laboratory Use

    E1272 Specification for Laboratory Glass Graduated Cylinders