ASTM D75 / D75M - 14 Standard Practice for Sampling Aggregates


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    C29/C29M Standard Test Method for Bulk Density ("Unit Weight") and Voids in Aggregate

    C33/C33M Standard Specification for Concrete Aggregates

    C35 Standard Specification for Inorganic Aggregates for Use in Gypsum Plaster

    C40/C40M Standard Test Method for Organic Impurities in Fine Aggregates for Concrete

    C87/C87M Standard Test Method for Effect of Organic Impurities in Fine Aggregate on Strength of Mortar

    C88 Standard Test Method for Soundness of Aggregates by Use of Sodium Sulfate or Magnesium Sulfate

    C110 Standard Test Methods for Physical Testing of Quicklime, Hydrated Lime, and Limestone

    C117 Standard Test Method for Materials Finer than 75-μm (No. 200) Sieve in Mineral Aggregates by Washing

    C123/C123M Standard Test Method for Lightweight Particles in Aggregate

    C127 Standard Test Method for Density, Relative Density (Specific Gravity), and Absorption of Coarse Aggregate

    C128 Standard Test Method for Density, Relative Density (Specific Gravity), and Absorption of Fine Aggregate

    C136 Standard Test Method for Sieve Analysis of Fine and Coarse Aggregates

    C144 Standard Specification for Aggregate for Masonry Mortar

    C233/C233M Standard Test Method for Air-Entraining Admixtures for Concrete

    C289 Standard Test Method for Potential Alkali-Silica Reactivity of Aggregates (Chemical Method)

    C295/C295M Standard Guide for Petrographic Examination of Aggregates for Concrete

    C330/C330M Standard Specification for Lightweight Aggregates for Structural Concrete

    C331/C331M Standard Specification for Lightweight Aggregates for Concrete Masonry Units

    C332 Standard Specification for Lightweight Aggregates for Insulating Concrete

    C404 Standard Specification for Aggregates for Masonry Grout

    C494/C494M Standard Specification for Chemical Admixtures for Concrete

    C535 Standard Test Method for Resistance to Degradation of Large-Size Coarse Aggregate by Abrasion and Impact in the Los Angeles Machine

    C566 Standard Test Method for Total Evaporable Moisture Content of Aggregate by Drying

    C586 Standard Test Method for Potential Alkali Reactivity of Carbonate Rocks as Concrete Aggregates (Rock-Cylinder Method)

    C641 Standard Test Method for Iron Staining Materials in Lightweight Concrete Aggregates

    C702/C702M Standard Practice for Reducing Samples of Aggregate to Testing Size

    C897 Standard Specification for Aggregate for Job-Mixed Portland Cement-Based Plasters

    C1017/C1017M Standard Specification for Chemical Admixtures for Use in Producing Flowing Concrete

    C1077 Standard Practice for Agencies Testing Concrete and Concrete Aggregates for Use in Construction and Criteria for Testing Agency Evaluation

    C1105 Standard Test Method for Length Change of Concrete Due to Alkali-Carbonate Rock Reaction

    C1252 Standard Test Methods for Uncompacted Void Content of Fine Aggregate (as Influenced by Particle Shape, Surface Texture, and Grading)

    C1293 Standard Test Method for Determination of Length Change of Concrete Due to Alkali-Silica Reaction

    C1356 Standard Test Method for Quantitative Determination of Phases in Portland Cement Clinker by Microscopical Point-Count Procedure

    C1451 Standard Practice for Determining Uniformity of Ingredients of Concrete From a Single Source

    C1524 Standard Test Method for Water-Extractable Chloride in Aggregate (Soxhlet Method)

    C1646/C1646M Standard Practice for Making and Curing Test Specimens for Evaluating Resistance of Coarse Aggregate to Freezing and Thawing in Air-Entrained Concrete

    C1761/C1761M Standard Specification for Lightweight Aggregate for Internal Curing of Concrete

    C1777 Standard Test Method for Rapid Determination of the Methylene Blue Value for Fine Aggregate or Mineral Filler Using a Colorimeter

    D448 Standard Classification for Sizes of Aggregate for Road and Bridge Construction

    D692/D692M Standard Specification for Coarse Aggregate for Bituminous Paving Mixtures

    D1073 Standard Specification for Fine Aggregate for Bituminous Paving Mixtures

    D1074 Standard Test Method for Compressive Strength of Bituminous Mixtures

    D1139/D1139M Standard Specification for Aggregate for Single or Multiple Bituminous Surface Treatments

    D1140 Standard Test Methods for Amount of Material in Soils Finer than No. 200 (75-μm) Sieve

    D1241 Standard Specification for Materials for Soil-Aggregate Subbase, Base, and Surface Courses

    D1863/D1863M Standard Specification for Mineral Aggregate Used on Built-Up Roofs

    D1864/D1864M Standard Test Method for Moisture in Mineral Aggregate Used on Built-Up Roofs

    D1865/D1865M Standard Test Method for Hardness of Mineral Aggregate Used on Built-Up Roofs

    D2419 Standard Test Method for Sand Equivalent Value of Soils and Fine Aggregate

    D2940/D2940M Standard Specification for Graded Aggregate Material For Bases or Subbases for Highways or Airports

    D3319 Standard Practice for Accelerated Polishing of Aggregates Using the British Wheel

    D3665 Standard Practice for Random Sampling of Construction Materials

    D3744/D3744M Standard Test Method for Aggregate Durability Index

    D3987 Standard Practice for Shake Extraction of Solid Waste with Water

    D4125/D4125M Standard Test Methods for Asphalt Content of Bituminous Mixtures by the Nuclear Method

    D4215 Standard Specification for Cold-Mixed, Cold-Laid Bituminous Paving Mixtures

    D4223/D4223M Standard Practice for Preparation of Test Specimens of Asphalt-Stabilized Soils

    D4318 Standard Test Methods for Liquid Limit, Plastic Limit, and Plasticity Index of Soils

    D4791 Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate

    D4792/D4792M Standard Test Method for Potential Expansion of Aggregates from Hydration Reactions

    D4793 Standard Test Method for Sequential Batch Extraction of Waste with Water

    D4943 Standard Test Method for Shrinkage Factors of Soils by the Wax Method

    D5013 Standard Practices for Sampling Wastes from Pipes and Other Point Discharges

    D5081/D5081M Standard Test Method for Aggregate Layer Hiding Power

    D5106 Standard Specification for Steel Slag Aggregates for Bituminous Paving Mixtures

    D5148 Standard Test Method for Centrifuge Kerosine Equivalent

    D5233 Standard Test Method for Single Batch Extraction Method for Wastes

    D5284 Standard Test Method for Sequential Batch Extraction of Waste with Acidic Extraction Fluid

    D5369 Standard Practice for Extraction of Solid Waste Samples for Chemical Analysis Using Soxhlet Extraction

    D5744 Standard Test Method for Laboratory Weathering of Solid Materials Using a Humidity Cell

    D5821 Standard Test Method for Determining the Percentage of Fractured Particles in Coarse Aggregate

    D5883 Standard Guide for Use of Rotary Kiln Produced Expanded Shale, Clay or Slate (ESCS) as a Mineral Amendment in Topsoil Used for Landscaping and Related Purposes

    D5918 Standard Test Methods for Frost Heave and Thaw Weakening Susceptibility of Soils

    D6155 Standard Specification for Nontraditional Coarse Aggregates for Bituminous Paving Mixtures

    D6234 Standard Test Method for Shake Extraction of Mining Waste by the Synthetic Precipitation Leaching Procedure

    D6307 Standard Test Method for Asphalt Content of Hot-Mix Asphalt by Ignition Method

    D6704 Standard Test Method for Determining the Workability of Asphalt Cold Mix Patching Material

    D6825 Standard Guide for Placement of Riprap Revetments

    D6932/D6932M Standard Guide for Materials and Construction of Open-Graded Friction Course Plant Mixtures

    D7000 Standard Test Method for Sweep Test of Bituminous Emulsion Surface Treatment Samples

    D7172 Standard Test Method for Determining the Relative Density (Specific Gravity) and Absorption of Fine Aggregates Using Infrared

    D7196 Standard Test Method for Raveling Test of Cold Mixed Emulsified Asphalt Samples

    D7312 Standard Test Method for Determining the Permanent Shear Strain and Complex Shear Modulus of Asphalt Mixtures Using the Superpave Shear Tester (SST)

    D7370 Standard Test Method for Determination of Relative Density and Absorption of Fine, Coarse and Blended Aggregate Using Combined Vacuum Saturation and Rapid Submersion

    D7460 Standard Test Method for Determining Fatigue Failure of Compacted Asphalt Concrete Subjected to Repeated Flexural Bending

    D7655/D7655M Standard Classification for Size of Aggregate Used as Ballast for Membrane Roof Systems

    D7762 Standard Practice for Design of Stabilization of Soil and Soil-Like Materials with Self-Cementing Fly Ash

    E889 Standard Test Method for Composition or Purity of a Solid Waste Materials Stream

    E1107 Standard Test Method for Measuring the Throughput of Resource-Recovery Unit Operations

    E1109 Standard Test Method for Determining the Bulk Density of Solid Waste Fractions

    E2060 Standard Guide for Use of Coal Combustion Products for Solidification/Stabilization of Inorganic Wastes

    E2243 Standard Guide for Use of Coal Combustion Products (CCPs) for Surface Mine Reclamation: Re-contouring and Highwall Reclamation

    E2277 Standard Guide for Design and Construction of Coal Ash Structural Fills

    E2278 Standard Guide for Use of Coal Combustion Products (CCPs) for Surface Mine Reclamation: Revegetation and Mitigation of Acid Mine Drainage

    E2788 Standard Specification for Use of Expanded Shale, Clay and Slate (ESCS) as a Mineral Component in the Growing Media and the Drainage Layer for Vegetative (Green) Roof Systems

    F555 Standard Test Method for Motor Life Evaluation of an Upright Vacuum Cleaner

    F608 Standard Test Method for Evaluation of Carpet Embedded Dirt Removal Effectiveness of Household/Commercial Vacuum Cleaners

    F922 Standard Test Method for Motor Life Evaluation of an Electric Motorized Nozzle

    F1284 Standard Test Method for Evaluating Carpet Embedded Dirt Removal Effectiveness of Residential Central Vacuum Cleaning Systems

    F1601 Standard Test Method for Motor Life Evaluation of an Electric Motorized Nozzle for Central Vacuum Cleaning Systems

    F1692 Standard Test Method for Life Evaluation of a Turbine-Powered Nozzle for Household Central Vacuum Cleaning Systems

    F2607 Standard Test Method for Measuring the Hard Surface Floor-Cleaning Ability of Household/Commercial Vacuum Cleaners

    F2797 Standard Test Method for Evaluating Edge Cleaning Effectiveness of Vacuum Cleaners

    F2980 Standard Test Method for Analysis of Heavy Metals in Glass by Field Portable X-Ray Fluorescence (XRF)


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    C125 Terminology Relating to Concrete and Concrete Aggregates

    C702 Practice for Reducing Samples of Aggregate to Testing Size

    D8 Terminology Relating to Materials for Roads and Pavements

    D2234/D2234M Practice for Collection of a Gross Sample of Coal

    D3665 Practice for Random Sampling of Construction Materials

    D3666 Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials

    E105 Practice for Probability Sampling of Materials

    E122 Practice for Calculating Sample Size to Estimate, With Specified Precision, the Average for a Characteristic of a Lot or Process

    E141 Practice for Acceptance of Evidence Based on the Results of Probability Sampling