ASTM D704 - 99(2012) Standard Specification for Melamine-Formaldehyde Molding Compounds


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    There are currently no referencing documents for this standard.


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    D149 Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies

    D150 Test Methods for AC Loss Characteristics and Permittivity (Dielectric Constant) of Solid Electrical Insulation

    D256 Test Methods for Determining the Izod Pendulum Impact Resistance of Plastics

    D495 Test Method for High-Voltage, Low-Current, Dry Arc Resistance of Solid Electrical Insulation

    D570 Test Method for Water Absorption of Plastics

    D618 Practice for Conditioning Plastics for Testing

    D648 Test Method for Deflection Temperature of Plastics Under Flexural Load in the Edgewise Position

    D731 Test Method for Molding Index of Thermosetting Molding Powder

    D790 Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials

    D792 Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement

    D883 Terminology Relating to Plastics

    D1895 Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials

    D1896 Practice for Transfer Molding Test Specimens of Thermosetting Compounds

    D3638 Test Method for Comparative Tracking Index of Electrical Insulating Materials

    D3795 Test Method for Thermal Flow, Cure, and Behavior Properties of Pourable Thermosetting Materials by Torque Rheometer

    D3892 Practice for Packaging/Packing of Plastics

    D5224 Practice for Compression Molding Test Specimens of Thermosetting Molding Compounds

    D6289 Test Method for Measuring Shrinkage from Mold Dimensions of Molded Thermosetting Plastics

    Manual7 Manual on Presentation of Data and Control Chart Analysis, 8th Edition Available from ASTM International Headquarters. Request MNL7-8TH.