ASTM D6779 - 12a Standard Classification System for and Basis of Specification for Polyamide Molding and Extrusion Materials (PA)


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    D789 Standard Test Methods for Determination of Solution Viscosities of Polyamide (PA)

    D955 Standard Test Method of Measuring Shrinkage from Mold Dimensions of Thermoplastics

    D4000 Standard Classification System for Specifying Plastic Materials

    D5628 Standard Test Method for Impact Resistance of Flat, Rigid Plastic Specimens by Means of a Falling Dart (Tup or Falling Mass)

    D5740 Standard Guide for Writing Material Standards in the Classification D4000 Format

    D5989 Standard Specification for Extruded and Monomer Cast Shapes Made from Nylon (PA)

    F2600 Standard Specification for Electrofusion Type Polyamide-11 Fittings for Outside Diameter Controlled Polyamide-11 Pipe and Tubing

    F2767 Standard Specification for Electrofusion Type Polyamide-12 Fittings for Outside Diameter Controlled Polyamide-12 Pipe and Tubing for Gas Distribution

    F2785 Standard Specification for Polyamide 12 Gas Pressure Pipe, Tubing, and Fittings

    G175 Standard Test Method for Evaluating the Ignition Sensitivity and Fault Tolerance of Oxygen Pressure Regulators Used for Medical and Emergency Applications


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    D257 Test Methods for DC Resistance or Conductance of Insulating Materials

    D789 Test Methods for Determination of Solution Viscosities of Polyamide (PA)

    D792 Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement

    D883 Terminology Relating to Plastics

    D1600 Terminology for Abbreviated Terms Relating to Plastics

    D3892 Practice for Packaging/Packing of Plastics

    D4000 Classification System for Specifying Plastic Materials

    D5740 Guide for Writing Material Standards in the Classification Format

    D6260 Test Method for Gravimetric Determination of Carbon Black in Nylon Materials (PA)

    D7209 Guide for Waste Reduction, Resource Recovery, and Use of Recycled Polymeric Materials and Products

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications