ASTM D6439 - 11 Standard Guide for Cleaning, Flushing, and Purification of Steam, Gas, and Hydroelectric Turbine Lubrication Systems


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    D4304 Standard Specification for Mineral and Synthetic Lubricating Oil Used in Steam or Gas Turbines

    D4378 Standard Practice for In-Service Monitoring of Mineral Turbine Oils for Steam, Gas, and Combined Cycle Turbines

    D7720 Standard Guide for Statistically Evaluating Measurand Alarm Limits when Using Oil Analysis to Monitor Equipment and Oil for Fitness and Contamination


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    D445 Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)

    D664 Test Method for Acid Number of Petroleum Products by Potentiometric Titration

    D974 Test Method for Acid and Base Number by Color-Indicator Titration

    D2272 Test Method for Oxidation Stability of Steam Turbine Oils by Rotating Pressure Vessel

    D4241 Practice for Design of Gas Turbine Generator Lubricating Oil Systems

    D4248 Practice for Design of Steam Turbine Generator Oil Systems

    D4378 Practice for In-Service Monitoring of Mineral Turbine Oils for Steam and Gas Turbines

    D4898 Test Method for Insoluble Contamination of Hydraulic Fluids by Gravimetric Analysis

    D6304 Test Method for Determination of Water in Petroleum Products, Lubricating Oils, and Additives by Coulometric Karl Fischer Titration

    D6810 Test Method for Measurement of Hindered Phenolic Antioxidant Content in Non-Zinc Turbine Oils by Linear Sweep Voltammetry

    D6971 Test Method for Measurement of Hindered Phenolic and Aromatic Amine Antioxidant Content in Non-zinc Turbine Oils by Linear Sweep Voltammetry

    D7155 Practice for Evaluating Compatibility of Mixtures of Turbine Lubricating Oils

    D7546 Test Method for Determination of Moisture in New and In-Service Lubricating Oils and Additives by Relative Humidity Sensor

    D7647 Test Method for Automatic Particle Counting of Lubricating and Hydraulic Fluids Using Dilution Techniques to Eliminate the Contribution of Water and Interfering Soft Particles by Light Extinction

    F311 Practice for Processing Aerospace Liquid Samples for Particulate Contamination Analysis Using Membrane Filters

    F312 Test Methods for Microscopical Sizing and Counting Particles from Aerospace Fluids on Membrane Filters