ASTM D5 / D5M - 13 Standard Test Method for Penetration of Bituminous Materials


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    A849 Standard Specification for Post-Applied Coatings, Pavings, and Linings for Corrugated Steel Sewer and Drainage Pipe

    C782 Standard Test Method for Softness of Preformed Tape Sealants

    D6/D6M Standard Test Method for Loss on Heating of Oil and Asphaltic Compounds

    D41/D41M Standard Specification for Asphalt Primer Used in Roofing, Dampproofing, and Waterproofing

    D113 Standard Test Method for Ductility of Bituminous Materials

    D243 Standard Test Method for Residue of Specified Penetration

    D244 Standard Test Methods and Practices for Emulsified Asphalts

    D312 Standard Specification for Asphalt Used in Roofing

    D449/D449M Standard Specification for Asphalt Used in Dampproofing and Waterproofing

    D946/D946M Standard Specification for Penetration-Graded Asphalt Cement for Use in Pavement Construction

    D977 Standard Specification for Emulsified Asphalt

    D1321 Standard Test Method for Needle Penetration of Petroleum Waxes

    D1669/D1669M Standard Practice for Preparation of Test Panels for Accelerated and Outdoor Weathering of Bituminous Coatings

    D1754/D1754M Standard Test Method for Effect of Heat and Air on Asphaltic Materials (Thin-Film Oven Test)

    D2027/D2027M Standard Specification for Cutback Asphalt (Medium-Curing Type)

    D2028/D2028M Standard Specification for Cutback Asphalt (Rapid-Curing Type)

    D2397/D2397M Standard Specification for Cationic Emulsified Asphalt

    D2521/D2521M Standard Specification for Asphalt Used in Canal, Ditch, and Pond Lining

    D3141/D3141M Standard Specification for Asphalt for Undersealing Portland-Cement Concrete Pavements

    D3381/D3381M Standard Specification for Viscosity-Graded Asphalt Cement for Use in Pavement Construction

    D3462/D3462M Standard Specification for Asphalt Shingles Made from Glass Felt and Surfaced with Mineral Granules

    D3666 Standard Specification for Minimum Requirements for Agencies Testing and Inspecting Road and Paving Materials

    D3745 Standard Practice for Installation of Prefabricated Asphalt Reservoir, Pond, Canal, and Ditch Liner (Exposed Type)

    D3791/D3791M Standard Practice for Evaluating the Effects of Heat on Asphalts

    D4280 Standard Specification for Extended Life Type, Nonplowable, Raised Retroreflective Pavement Markers

    D4383 Standard Specification for Plowable, Raised Retroreflective Pavement Markers

    D5078/D5078M Standard Specification for Crack Filler, Hot-Applied, for Asphalt Concrete and Portland Cement Concrete Pavements

    D5329 Standard Test Methods for Sealants and Fillers, Hot-Applied, for Joints and Cracks in Asphaltic and Portland Cement Concrete Pavements

    D5505 Standard Practice for Classifying Emulsified Recycling Agents

    D5710/D5710M Standard Specification for Trinidad Lake Modified Asphalt

    D5801 Standard Test Method for Toughness and Tenacity of Bituminous Materials

    D6084/D6084M Standard Test Method for Elastic Recovery of Bituminous Materials by Ductilometer

    D6114/D6114M Standard Specification for Asphalt-Rubber Binder

    D6152/D6152M Standard Specification for SEBS-Modified Mopping Asphalt Used in Roofing

    D6154 Standard Specification for Chemically Modified Asphalt Cement for Use in Pavement Construction

    D6297 Standard Specification for Asphaltic Plug Joints for Bridges

    D7654/D7654M Standard Specification for Asphalt Used in Roofing Measured by Dynamic Shear Rheometer

    There are currently no referencing documents for this standard.


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    D36 Test Method for Softening Point of Bitumen (Ring-and-Ball Apparatus)

    D244 Test Methods and Practices for Emulsified Asphalts

    E1 Specification for ASTM Liquid-in-Glass Thermometers

    E77 Test Method for Inspection and Verification of Thermometers

    E1137/E1137M Specification for Industrial Platinum Resistance Thermometers

    E2251 Specification for Liquid-in-Glass ASTM Thermometers with Low-Hazard Precision Liquids