ASTM D3261 - 12e1 Standard Specification for Butt Heat Fusion Polyethylene (PE) Plastic Fittings for Polyethylene (PE) Plastic Pipe and Tubing


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    D2513 Standard Specification for Polyethylene (PE) Gas Pressure Pipe, Tubing, and Fittings

    F412 Standard Terminology Relating to Plastic Piping Systems

    F645 Standard Guide for Selection, Design, and Installation of Thermoplastic Water- Pressure Piping Systems

    F905 Standard Practice for Qualification of Polyethylene Saddle-Fused Joints

    F2206 Standard Specification for Fabricated Fittings of Butt-Fused Polyethylene (PE) Plastic Pipe, Fittings, Sheet Stock, Plate Stock, or Block Stock

    F2619/F2619M Standard Specification for High-Density Polyethylene (PE) Line Pipe

    F2880 Standard Specification for Lap-Joint Type Flange Adapters for Polyethylene Pressure Pipe in Nominal Pipe Sizes 3/4 in. to 65 in.


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    D1598 Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure

    D1599 Test Method for Resistance to Short-Time Hydraulic Pressure of Plastic Pipe, Tubing, and Fittings

    D1600 Terminology for Abbreviated Terms Relating to Plastics

    D2122 Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings

    D2513 Specification for Polyethylene (PE) Gas Pressure Pipe, Tubing, and Fittings

    D3350 Specification for Polyethylene Plastics Pipe and Fittings Materials

    F412 Terminology Relating to Plastic Piping Systems