ASTM D2839 - 10 Standard Practice for Use of a Melt Index Strand for Determining Density of Polyethylene


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    D1248 Standard Specification for Polyethylene Plastics Extrusion Materials for Wire and Cable

    D1505 Standard Test Method for Density of Plastics by the Density-Gradient Technique

    D2103 Standard Specification for Polyethylene Film and Sheeting

    D3350 Standard Specification for Polyethylene Plastics Pipe and Fittings Materials

    D4976 Standard Specification for Polyethylene Plastics Molding and Extrusion Materials

    D7774 Standard Test Method for Flexural Fatigue Properties of Plastics

    D7791 Standard Test Method for Uniaxial Fatigue Properties of Plastics


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    D1238 Test Method for Melt Flow Rates of Thermoplastics by Extrusion Plastometer

    D1505 Test Method for Density of Plastics by the Density-Gradient Technique

    D4703 Practice for Compression Molding Thermoplastic Materials into Test Specimens, Plaques, or Sheets