ASTM D1308 - 02(2013) Standard Test Method for Effect of Household Chemicals on Clear and Pigmented Organic Finishes


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    C722 Standard Specification for Chemical-Resistant Monolithic Floor Surfacings

    C1315 Standard Specification for Liquid Membrane-Forming Compounds Having Special Properties for Curing and Sealing Concrete

    C1486 Standard Practice for Testing Chemical-Resistant Broadcast and Slurry-Broadcast Resin Monolithic Floor Surfacings

    D333 Standard Guide for Clear and Pigmented Lacquers

    D2454 Standard Practice for Determining the Effect of Overbaking on Organic Coatings

    D3002 Standard Guide for Evaluation of Coatings Applied to Plastics

    D3322 Standard Practice for Testing Primers and Primer Surfacers Over Preformed Metal

    D3451 Standard Guide for Testing Coating Powders and Powder Coatings

    D3730 Standard Guide for Testing High-Performance Interior Architectural Wall Coatings

    D3794 Standard Guide for Testing Coil Coatings

    D4802 Standard Specification for Poly(Methyl Methacrylate) Acrylic Plastic Sheet

    D5146 Standard Guide to Testing Solvent-Borne Architectural Coatings

    D5324 Standard Guide for Testing Water-Borne Architectural Coatings

    D6577 Standard Guide for Testing Industrial Protective Coatings

    D6688 Standard Practice for Relative Resistance of Printed Matter to Liquid Chemicals by a Sandwich Technique

    D7190 Standard Practice to Evaluate Leaching of Water-Soluble Materials from Latex Paint Films

    E1795 Standard Specification for Non-Reinforced Liquid Coating Encapsulation Products for Leaded Paint in Buildings

    E1797 Standard Specification for Reinforced Liquid Coating Encapsulation Products for Leaded Paint in Buildings

    F793 Standard Classification of Wall Covering by Use Characteristics

    F940 Standard Practice for Quality Control Receipt Inspection Procedures for Protective Coatings (Paint), Used in Marine Construction and Shipbuilding

    F1138 Standard Specification for Spray Shields for Mechanical Joints


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    D609 Practice for Preparation of Cold-Rolled Steel Panels for Testing Paint, Varnish, Conversion Coatings, and Related Coating Products