ASTM C990M - 09(2014) Standard Specification for Joints for Concrete Pipe, Manholes, and Precast Box Sections Using Preformed Flexible Joint Sealants (Metric)


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    There are currently no referencing documents for this standard.


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    C14M Specification for Nonreinforced Concrete Sewer, Storm Drain, and Culvert Pipe (Metric)

    C76M Specification for Reinforced Concrete Culvert, Storm Drain, and Sewer Pipe (Metric)

    C478M Specification for Precast Reinforced Concrete Manhole Sections (Metric)

    C506M Specification for Reinforced Concrete Arch Culvert, Storm Drain, and Sewer Pipe (Metric)

    C507M Specification for Reinforced Concrete Elliptical Culvert, Storm Drain, and Sewer Pipe (Metric)

    C655M Specification for Reinforced Concrete D-Load Culvert, Storm Drain, and Sewer Pipe (Metric)

    C822 Terminology Relating to Concrete Pipe and Related Products

    C972 Test Method for Compression-Recovery of Tape Sealant

    C985M Specification for Nonreinforced Concrete Specified Strength Culvert, Storm Drain, and Sewer Pipe (Metric)

    C1433M Specification for Precast Reinforced Concrete Monolithic Box Sections for Culverts, Storm Drains, and Sewers (Metric)

    C1504M Specification for Manufacture of Precast Reinforced Concrete Three-Sided Structures for Culverts and Storm Drains (Metric)

    C1577 Specification for Precast Reinforced Concrete Monolithic Box Sections for Culverts, Storm Drains, and Sewers Designed According to AASHTO LRFD

    D4 Test Method for Bitumen Content

    D6 Test Method for Loss on Heating of Oil and Asphaltic Compounds

    D36 Test Method for Softening Point of Bitumen (Ring-and-Ball Apparatus)

    D71 Test Method for Relative Density of Solid Pitch and Asphalt (Displacement Method)

    D92 Test Method for Flash and Fire Points by Cleveland Open Cup Tester

    D113 Test Method for Ductility of Bituminous Materials

    D217 Test Methods for Cone Penetration of Lubricating Grease

    D297 Test Methods for Rubber Products--Chemical Analysis