ASTM C954 - 11 Standard Specification for Steel Drill Screws for the Application of Gypsum Panel Products or Metal Plaster Bases to Steel Studs from 0.033 in. (0.84 mm) to 0.112 in. (2.84 mm) in Thickness


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    C11 Standard Terminology Relating to Gypsum and Related Building Materials and Systems

    C840 Standard Specification for Application and Finishing of Gypsum Board

    C841 Standard Specification for Installation of Interior Lathing and Furring

    C844 Standard Specification for Application of Gypsum Base to Receive Gypsum Veneer Plaster

    C955 Standard Specification for Load-Bearing (Transverse and Axial) Steel Studs, Runners (Tracks), and Bracing or Bridging for Screw Application of Gypsum Panel Products and Metal Plaster Bases

    C1007 Standard Specification for Installation of Load Bearing (Transverse and Axial) Steel Studs and Related Accessories

    C1063 Standard Specification for Installation of Lathing and Furring to Receive Interior and Exterior Portland Cement-Based Plaster

    C1280 Standard Specification for Application of Exterior Gypsum Panel Products for Use as Sheathing

    C1787 Standard Specification for Installation of Non Metallic Plaster Bases (Lath) Used with Portland Cement Based Plaster in Vertical Wall Applications


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    A510 Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel

    C11 Terminology Relating to Gypsum and Related Building Materials and Systems

    C847 Specification for Metal Lath

    C955 Specification for Load-Bearing (Transverse and Axial) Steel Studs, Runners (Tracks), and Bracing or Bridging for Screw Application of Gypsum Panel Products and Metal Plaster Bases

    C1396/C1396M Specification for Gypsum Board

    C1513 Specification for Steel Tapping Screws for Cold-Formed Steel Framing Connections