ASTM C877M - 02(2009) Standard Specification for External Sealing Bands for Concrete Pipe, Manholes, and Precast Box Sections (Metric)


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    There are currently no referencing documents for this standard.


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    A167 Specification for Stainless and Heat-Resisting Chromium-Nickel Steel Plate, Sheet, and Strip

    C14M Specification for Nonreinforced Concrete Sewer, Storm Drain, and Culvert Pipe (Metric)

    C76M Specification for Reinforced Concrete Culvert, Storm Drain, and Sewer Pipe (Metric)

    C412M Specification for Concrete Drain Tile (Metric)

    C478M Specification for Precast Reinforced Concrete Manhole Sections (Metric)

    C506M Specification for Reinforced Concrete Arch Culvert, Storm Drain, and Sewer Pipe (Metric)

    C507M Specification for Reinforced Concrete Elliptical Culvert, Storm Drain, and Sewer Pipe (Metric)

    C655M Specification for Reinforced Concrete D-Load Culvert, Storm Drain, and Sewer Pipe (Metric)

    C681 Test Method for Volatility of Oil- and Resin-Based, Knife-Grade, Channel Glazing Compounds

    C766 Test Method for Adhesion After Impact of Preformed Tape Sealants

    C822 Terminology Relating to Concrete Pipe and Related Products

    C985M Specification for Nonreinforced Concrete Specified Strength Culvert, Storm Drain, and Sewer Pipe (Metric)

    C1417M Specification for Manufacture of Reinforced Concrete Sewer, Storm Drain, and Culvert Pipe for Direct Design (Metric)

    C1433M Specification for Precast Reinforced Concrete Monolithic Box Sections for Culverts, Storm Drains, and Sewers (Metric)

    D36 Test Method for Softening Point of Bitumen (Ring-and-Ball Apparatus)

    D217 Test Methods for Cone Penetration of Lubricating Grease

    D395 Test Methods for Rubber Property--Compression Set

    D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension

    D471 Test Method for Rubber Property--Effect of Liquids

    D570 Test Method for Water Absorption of Plastics

    D573 Test Method for Rubber--Deterioration in an Air Oven

    D624 Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers

    D882 Test Method for Tensile Properties of Thin Plastic Sheeting

    D1171 Test Method for Rubber Deterioration--Surface Ozone Cracking Outdoors or Chamber (Triangular Specimens)

    D1278 Test Methods for Rubber from Natural Sources--Chemical Analysis

    D1682 Test Method for Breaking Load and Elongation of Textile Fabric

    D1963 Test Method for Specific Gravity of Drying Oils, Varnishes, Resins, and Related Materials at 25/25C

    D2202 Test Method for Slump of Sealants

    D2240 Test Method for Rubber Property--Durometer Hardness

    D3407 Test Methods for Joint Sealants, Hot-Poured, for Concrete and Asphalt Pavements

    D3953 Specification for Strapping, Flat Steel and Seals