ASTM C794 - 10 Standard Test Method for Adhesion-in-Peel of Elastomeric Joint Sealants


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    C836/C836M Standard Specification for High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane for Use with Separate Wearing Course

    C920 Standard Specification for Elastomeric Joint Sealants

    C957/C957M Standard Specification for High-Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane With Integral Wearing Surface

    C1021 Standard Practice for Laboratories Engaged in Testing of Building Sealants

    C1184 Standard Specification for Structural Silicone Sealants

    C1193 Standard Guide for Use of Joint Sealants

    C1249 Standard Guide for Secondary Seal for Sealed Insulating Glass Units for Structural Sealant Glazing Applications

    C1401 Standard Guide for Structural Sealant Glazing

    C1472 Standard Guide for Calculating Movement and Other Effects When Establishing Sealant Joint Width

    C1481 Standard Guide for Use of Joint Sealants with Exterior Insulation and Finish Systems (EIFS)

    C1521 Standard Practice for Evaluating Adhesion of Installed Weatherproofing Sealant Joints

    C1564 Standard Guide for Use of Silicone Sealants for Protective Glazing Systems

    D6083 Standard Specification for Liquid Applied Acrylic Coating Used in Roofing

    E1399/E1399M Standard Test Method for Cyclic Movement and Measuring the Minimum and Maximum Joint Widths of Architectural Joint Systems

    E2112 Standard Practice for Installation of Exterior Windows, Doors and Skylights

    E2813 Standard Practice for Building Enclosure Commissioning


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    C717 Terminology of Building Seals and Sealants

    C1375 Guide for Substrates Used in Testing Building Seals and Sealants

    E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method