ASTM C1093 - 13ae1 Standard Practice for Accreditation of Testing Agencies for Masonry


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    C67 Standard Test Methods for Sampling and Testing Brick and Structural Clay Tile

    C140/C140M Standard Test Methods for Sampling and Testing Concrete Masonry Units and Related Units

    C270 Standard Specification for Mortar for Unit Masonry

    C426 Standard Test Method for Linear Drying Shrinkage of Concrete Masonry Units

    C780 Standard Test Method for Preconstruction and Construction Evaluation of Mortars for Plain and Reinforced Unit Masonry

    C1019 Standard Test Method for Sampling and Testing Grout

    C1262 Standard Test Method for Evaluating the Freeze-Thaw Durability of Dry-Cast Segmental Retaining Wall Units and Related Concrete Units

    C1314 Standard Test Method for Compressive Strength of Masonry Prisms

    C1384 Standard Specification for Admixtures for Masonry Mortars

    C1405 Standard Specification for Glazed Brick (Single Fired, Brick Units)

    C1552 Standard Practice for Capping Concrete Masonry Units, Related Units and Masonry Prisms for Compression Testing

    C1660 Standard Specification for Thin-bed Mortar for Autoclaved Aerated Concrete (AAC) Masonry

    C1713 Standard Specification for Mortars for the Repair of Historic Masonry

    C1716/C1716M Standard Specification for Compression Testing Machine Requirements for Concrete Masonry Units, Related Units, and Prisms

    C1731 Standard Specification for Concrete Floor Tile

    E329 Standard Specification for Agencies Engaged in Construction Inspection, Testing, or Special Inspection


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    C67 Test Methods for Sampling and Testing Brick and Structural Clay Tile

    C109/C109M Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)

    C117 Test Method for Materials Finer than 75-m (No. 200) Sieve in Mineral Aggregates by Washing

    C136 Test Method for Sieve Analysis of Fine and Coarse Aggregates

    C140 Test Methods for Sampling and Testing Concrete Masonry Units and Related Units

    C143/C143M Test Method for Slump of Hydraulic-Cement Concrete

    C173/C173M Test Method for Air Content of Freshly Mixed Concrete by the Volumetric Method

    C185 Test Method for Air Content of Hydraulic Cement Mortar

    C230/C230M Specification for Flow Table for Use in Tests of Hydraulic Cement

    C231 Test Method for Air Content of Freshly Mixed Concrete by the Pressure Method

    C270 Specification for Mortar for Unit Masonry

    C305 Practice for Mechanical Mixing of Hydraulic Cement Pastes and Mortars of Plastic Consistency

    C470/C470M Specification for Molds for Forming Concrete Test Cylinders Vertically

    C780 Test Method for Preconstruction and Construction Evaluation of Mortars for Plain and Reinforced Unit Masonry

    C1072 Test Methods for Measurement of Masonry Flexural Bond Strength

    C1232 Terminology of Masonry

    C1506 Test Method for Water Retention of Hydraulic Cement-Based Mortars and Plasters

    E4 Practices for Force Verification of Testing Machines

    E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves