ASTM B580 - 79(2009) Standard Specification for Anodic Oxide Coatings on Aluminum


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    F992 Standard Specification for Valve Label Plates

    F993 Standard Specification for Valve Locking Devices

    F1476 Standard Specification for Performance of Gasketed Mechanical Couplings for Use in Piping Applications

    F1548 Standard Specification for Performance of Fittings for Use with Gasketed Mechanical Couplings Used in Piping Applications

    G103 Standard Practice for Evaluating Stress-Corrosion Cracking Resistance of Low Copper 7XXX Series Al-Zn-Mg-Cu Alloys in Boiling 6% Sodium Chloride Solution


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    B110 Method for Testing Dielectric Strength of Anodically Coated Aluminum

    B117 Practice for Operating Salt Spray (Fog) Apparatus

    B136 Method for Measurement of Stain Resistance of Anodic Coatings on Aluminum

    B137 Test Method for Measurement of Coating Mass Per Unit Area on Anodically Coated Aluminum

    B244 Test Method for Measurement of Thickness of Anodic Coatings on Aluminum and of Other Nonconductive Coatings on Nonmagnetic Basis Metals with Eddy-Current Instruments

    B368 Test Method for Copper-Accelerated Acetic Acid-Salt Spray (Fog) Testing (CASS Test)

    B457 Test Method for Measurement of Impedance of Anodic Coatings on Aluminum

    B487 Test Method for Measurement of Metal and Oxide Coating Thickness by Microscopical Examination of Cross Section

    B538 Method of FACT (Ford Anodized Aluminum Corrosion Test)

    B602 Test Method for Attribute Sampling of Metallic and Inorganic Coatings

    D658 Test Method for Abrasion Resistance of Organic Coatings by Air Blast Abrasive

    E429 Test Method for Measurement and Calculation of Reflecting Characteristics of Metallic Surfaces Using Integrating Sphere Instruments

    E430 Test Methods for Measurement of Gloss of High-Gloss Surfaces by Abridged Goniophotometry