ASTM A792 / A792M - 10 Standard Specification for Steel Sheet, 55 % Aluminum-Zinc Alloy-Coated by the Hot-Dip Process


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    A90/A90M Standard Test Method for Weight [Mass] of Coating on Iron and Steel Articles with Zinc or Zinc-Alloy Coatings

    A754/A754M Standard Test Method for Coating Weight (Mass) of Metallic Coatings on Steel by X-Ray Fluorescence

    A755/A755M Standard Specification for Steel Sheet, Metallic Coated by the Hot-Dip Process and Prepainted by the Coil-Coating Process for Exterior Exposed Building Products

    A787/A787M Standard Specification for Electric-Resistance-Welded Metallic-Coated Carbon Steel Mechanical Tubing

    A924/A924M Standard Specification for General Requirements for Steel Sheet, Metallic-Coated by the Hot-Dip Process

    A1003/A1003M Standard Specification for Steel Sheet, Carbon, Metallic- and Nonmetallic-Coated for Cold-Formed Framing Members

    C921 Standard Practice for Determining the Properties of Jacketing Materials for Thermal Insulation

    C955 Standard Specification for Load-Bearing (Transverse and Axial) Steel Studs, Runners (Tracks), and Bracing or Bridging for Screw Application of Gypsum Panel Products and Metal Plaster Bases

    E1514 Standard Specification for Structural Standing Seam Steel Roof Panel Systems


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    A90/A90M Test Method for Weight [Mass] of Coating on Iron and Steel Articles with Zinc or Zinc-Alloy Coatings

    A568/A568M Specification for Steel, Sheet, Carbon, Structural, and High-Strength, Low-Alloy, Hot-Rolled and Cold-Rolled, General Requirements for

    A902 Terminology Relating to Metallic Coated Steel Products

    A924/A924M Specification for General Requirements for Steel Sheet, Metallic-Coated by the Hot-Dip Process

    E517 Test Method for Plastic Strain Ratio r for Sheet Metal

    E646 Test Method for Tensile Strain-Hardening Exponents (n -Values) of Metallic Sheet Materials