ASTM A588 / A588M - 10 Standard Specification for High-Strength Low-Alloy Structural Steel, up to 50 ksi [345 MPa] Minimum Yield Point, with Atmospheric Corrosion Resistance


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    A563 Standard Specification for Carbon and Alloy Steel Nuts

    A563M Standard Specification for Carbon and Alloy Steel Nuts (Metric)

    A572/A572M Standard Specification for High-Strength Low-Alloy Columbium-Vanadium Structural Steel

    A595/A595M Standard Specification for Steel Tubes, Low-Carbon or High-Strength Low-Alloy, Tapered for Structural Use

    A709/A709M Standard Specification for Structural Steel for Bridges

    A786/A786M Standard Specification for Hot-Rolled Carbon, Low-Alloy, High-Strength Low-Alloy, and Alloy Steel Floor Plates

    A950/A950M Standard Specification for Fusion-Bonded Epoxy-Coated Structural Steel H-Piles and Sheet Piling

    A1065/A1065M Standard Specification for Cold-Formed Electric-Fusion (Arc) Welded High-Strength Low–Alloy Structural Tubing in Shapes, with 50 ksi [345 MPa] Minimum Yield Point

    D5973 Standard Specification for Elastomeric Strip Seals with Steel Locking Edge Rails Used in Expansion Joint Sealing

    D5977 Standard Specification for High Load Rotational Spherical Bearings for Bridges and Structures

    E1268 Standard Practice for Assessing the Degree of Banding or Orientation of Microstructures

    F436 Standard Specification for Hardened Steel Washers

    F436M Standard Specification for Hardened Steel Washers [Metric]

    F1852 Standard Specification for “Twist Off” Type Tension Control Structural Bolt/Nut/Washer Assemblies, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength

    G101 Standard Guide for Estimating the Atmospheric Corrosion Resistance of Low-Alloy Steels


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    A6/A6M Specification for General Requirements for Rolled Structural Steel Bars, Plates, Shapes, and Sheet Piling

    G101 Guide for Estimating the Atmospheric Corrosion Resistance of Low-Alloy Steels