ASTM A449 - 14 Standard Specification for Hex Cap Screws, Bolts and Studs, Steel, Heat Treated, 120/105/90 ksi Minimum Tensile Strength, General Use


    Citing ASTM Standards Citation data is made available by participants in CrossRefs Cited-by Linking service. A comprehensive list of citations to this standard are listed here.

    A325 Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength

    A563 Standard Specification for Carbon and Alloy Steel Nuts

    A760/A760M Standard Specification for Corrugated Steel Pipe, Metallic-Coated for Sewers and Drains

    A761/A761M Standard Specification for Corrugated Steel Structural Plate, Zinc-Coated, for Field-Bolted Pipe, Pipe-Arches, and Arches

    A762/A762M Standard Specification for Corrugated Steel Pipe, Polymer Precoated for Sewers and Drains

    B746/B746M Standard Specification for Corrugated Aluminum Alloy Structural Plate for Field-Bolted Pipe, Pipe-Arches, and Arches

    F436 Standard Specification for Hardened Steel Washers

    F1510 Standard Specification for Rotary Positive Displacement Pumps, Ships Use

    F1718 Standard Specification for Rotary Positive Displacement Distillate Fuel Pumps

    F2437 Standard Specification for Carbon and Alloy Steel Compressible-Washer-Type Direct Tension Indicators for Use with Cap Screws, Bolts, Anchors, and Studs

    F2482 Standard Specification for Load-Indicating Externally Threaded Fasteners

    F2798 Standard Specification for Sealless Lube Oil Pump with Oil Through Motor for Marine Applications


    Referenced ASTM Standards The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    A563 Specification for Carbon and Alloy Steel Nuts

    A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products

    B695 Specification for Coatings of Zinc Mechanically Deposited on Iron and Steel

    D3951 Practice for Commercial Packaging

    F436 Specification for Hardened Steel Washers

    F606 Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets

    F788/F788M Specification for Surface Discontinuities of Bolts, Screws, and Studs, Inch and Metric Series

    F1470 Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection

    F1789 Terminology for F16 Mechanical Fasteners

    F2329 Specification for Zinc Coating, Hot-Dip, Requirements for Application to Carbon and Alloy Steel Bolts, Screws, Washers, Nuts, and Special Threaded Fasteners

    G101 Guide for Estimating the Atmospheric Corrosion Resistance of Low-Alloy Steels