Abstract
This specification covers the requirements for austenitic grade stainless steel socket-set screws (SSS). The austenitic stainless steel socket set screw shall be designated as condition AF (solution annealed) or Condition CW (cold worked). The screw may be forged, formed, extruded, machined, or ground to meet the dimensional characteristics and performance requirements. The analysis of the screw material shall conform to the chemical composition specified. Chemical analysis; socket strength torque test; and corrosion resistance shall be performed to conform with the requirements specified.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers the requirements for austenitic grade stainless steel socket-set screws (SSS) sizes 0.060 through 0.500 in., in two conditions, AF and CW.
1.2 Units—The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
Note 1—A complete metric companion to Specification F 880 has been developed—F 880M; therefore, no metric equivalents are shown in this specification.
1.3 The following hazards caveat pertains only to Test Method Section, Section 12 of this specification. This standard does not purport to address (all of) the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents
A262 Practices for Detecting Susceptibility to Intergranular Attack in Austenitic Stainless Steels
A342 Test Methods for Permeability of Feebly Magnetic Materials
A380 Practice for Cleaning, Descaling, and Passivation of Stainless Steel Parts, Equipment, and Systems
A555/A555M Specification for General Requirements for Stainless Steel Wire and Wire Rods
A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
A967 Specification for Chemical Passivation Treatments for Stainless Steel Parts
D3951 Practice for Commercial Packaging
E18 Test Methods for Rockwell Hardness and Rockwell Superficial Hardness of Metallic Materials
F1470 Guide for Fastener Sampling for Specific Mechanical Properties and Performance Inspection
F593 Specification for Stainless Steel Bolts, Hex Cap Screws, and Studs
F788/F788M Specification for Surface Discontinuities of Bolts, Screws, and Studs, Inch and Metric Series
B18.3 Socket Cap, Shoulder and Set Screws, Inch Series
Index Terms
Screws--specifications; Socket set screws (SSS); Stainless steel screws--specifications; Steel screws--specifications; ICS Number Code 21.060.10; ICS Number Code 21.060.10
Citing ASTM Standards
[Back to Top]
