ASTM F835M

This specification covers the requirements for quenched and tempered alloy steel hexagon socket button (SBHCS) and flat countersunk (SFHCS) head cap screws. The screws shall be fabricated from alloy steel made to fine grain practice. The chemical composition of the screw material shall conform to the heat analysis specified. Hardness, tensile strength, yield strength, elongation, and area reduction shall be tested to meet the requirements prescribed.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket button (SBHCS) and flat countersunk (SFHCS) head cap screws M3 through M20 thread sizes having material properties of ISO 898/1 Property Class 12.9.

1.2 Fasteners meeting this specification are intended for shear type applications and have tensile requirements equivalent to ISO 898/1 Property Class 10.9.

1.3 The hazard statement pertains only to the test method section, Section 11 of this specification. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents

A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products
D3951 Practice for Commercial Packaging
E112 Test Methods for Determining Average Grain Size
E18 Test Methods for Rockwell Hardness and Rockwell Superficial Hardness of Metallic Materials
E3 Practice for Preparation of Metallographic Specimens
E384 Test Method for Microindentation Hardness of Materials
F606M Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, and Rivets [Metric]
F788/F788M Specification for Surface Discontinuities of Bolts, Screws, and Studs, Inch and Metric Series
898/1 Mechanical Properties of Fasteners, Bolts, Screws and Studs
B18.24.1 Part Identifying Number (PIN) Code System
B18.3.4M Hexagon Socket Button Head Cap Screws
B18.3.5M Hexagon Socket Flat Countersunk Head Cap Screws

Index Terms

cap screws; socket button head; socket flat counter-sunk head; alloy steel; steel; ICS Number Code 21.060.10

Citing ASTM Standards

[Back to Top]