1. Scope
1.1 These test methods cover the testing of fine wire, flat or round, approximately 0.010 in. (0.25 mm) and smaller in diameter or thickness, used in electronic devices and lamps.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents
B 63 Test Method for Resistivity of Metallically Conducting Resistance and Contact Materials
D 374 Test Methods for Thickness of Solid Electrical Insulation
F 16 Test Methods for Measuring Diameter or Thickness of Wire and Ribbon for Electronic Devices and Lamps
F 205 Test Method for Measuring Diameter of Fine Wire by Weighing
F 289 Specification for Molybdenum Wire and Rod for Electronic Applications
Index Terms
electrical resistance; electron devices; lamps; round and flat wire; tensile testing; ICS Number Code 29.060.10
DOI: 10.1520/F0219-96R02
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
