ASTM C490 / C490M

This practice is intended to provide standard requirements for apparatus common to many test methods used in connection with cement and concrete and standardized procedures for its use. The detailed requirements as to materials, mixtures, specimens, conditioning of specimens, number of specimens, ages at which measurements are to be made, interpretation of results, and precision and bias are left to be dealt with in specific test methods.

1. Scope

1.1 This practice covers the requirements for the apparatus and equipment used to prepare specimens for the determination of length change in hardened cement paste, mortar, and concrete, the apparatus and equipment used for the determination of these length changes, and the procedures for its use.

1.2 Methods for the preparation and curing of test specimens, conditions of testing and curing, and detailed procedures for calculating and reporting test results are contained in applicable test methods.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Index Terms

cement paste; comparator; concrete; length change apparatus; molds; mortar; Cement mortars; Cement pastes; Change in length; Concrete; Hardened concrete; Volumetric measurement--cement/concrete; ICS Number Code 91.100.10; 91.100.30; ICS Number Code 91.100.10; 91.100.30

Citing ASTM Standards

[Back to Top]