ASTM G98-91(1996)e1

    Historical Standard: ASTM G98-91(1996)e1 Standard Test Method for Galling Resistance of Materials

    SUPERSEDED (see Active link, below)


    Buy Standard (PDF)
    4 pages
    $44.40

    Active (view current version of standard)


    ASTM G98

    1. Scope

    1.1 This test method covers a laboratory test which ranks the galling resistance of material couples. Most galling studies have been conducted on bare metals and alloys; however, non-metallics, coatings, and surface modified alloys may also be evaluated by this test method.

    1.2 This test method is not designed for evaluating the galling resistance of material couples sliding under lubricated conditions because galling usually will not occur under lubricated sliding conditions using this test method.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    G40 Terminology Relating to Wear and Erosion

    G83 Test Method for Wear Testing with a Crossed-Cylinder Apparatus


    ICS Code

    ICS Number Code 17.040.20 (Properties of surfaces)

    UNSPSC Code

    UNSPSC Code


    DOI: 10.1520/G0098-91R96E01

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top