ASTM G94-92(1998)

    Historical Standard: ASTM G94-92(1998) Standard Guide for Evaluating Metals for Oxygen Service

    SUPERSEDED (see Active link, below)


    Buy Standard (PDF)
    24 pages
    $72.00

    Active (view current version of standard)


    ASTM G94

    1. Scope

    1.1 This guide applies to metallic materials under consideration for oxygen or oxygen-enriched fluid service, direct or indirect, as defined in Section 3. It is concerned primarily with the properties of a material associated with its relative susceptibility to ignition and propagation of combustion. It does not involve mechanical properties, potential toxicity, outgassing, reactions between various materials in the system, functional reliability, or performance characteristics such as aging, shredding, or sloughing of particles, except when these might contribute to an ignition.

    1.2 This document applies only to metals; nonmetals are covered in Guide G63.

    Note 1-The American Society for Testing and Materials takes no position respecting the validity of any evaluation methods asserted in connection with any item mentioned in this guide. Users of this guide are expressly advised that determination of the validity of any such evaluation methods and data and the risk of use of such evaluation methods and data are entirely their own responsibility. Note 2-In evaluating materials, any mixture with oxygen exceeding atmospheric concentration at pressures higher than atmospheric should be evaluated from the hazard point of view for possible significant increase in material combustibility.

    1.3 The values stated in SI units are to be regarded as the standard.

    1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D2512 Test Method for Compatibility of Materials with Liquid Oxygen (Impact Sensitivity Threshold and Pass-Fail Techniques)

    D2863 Test Method for Measuring the Minimum Oxygen Concentration to Support Candle-Like Combustion of Plastics (Oxygen Index)

    D4809 Test Method for Heat of Combustion of Liquid Hydrocarbon Fuels by Bomb Calorimeter (Precision Method)

    G63 Guide for Evaluating Nonmetallic Materials for Oxygen Service

    G72 Test Method for Autogenous Ignition Temperature of Liquids and Solids in a High-Pressure Oxygen-Enriched Environment

    G86 Test Method for Determining Ignition Sensitivity of Materials to Mechanical Impact in Ambient Liquid Oxygen and Pressurized Liquid and Gaseous Oxygen Environments

    G88 Guide for Designing Systems for Oxygen Service

    G93 Practice for Cleaning Methods and Cleanliness Levels for Material and Equipment Used in Oxygen-Enriched Environments

    G124 Test Method for Determining the Combustion Behavior of Metallic Materials in Oxygen-Enriched Atmospheres

    G126 Terminology Relating to the Compatibility and Sensitivity of Materials in Oxygen Enriched Atmospheres

    G128 Guide for Control of Hazards and Risks in Oxygen Enriched Systems

    ASTM Special Technical Publications (STPs) on the Flammability and Sensitivity of Materials in Oxyge

    ASTMSTPsinthiscatego 812, 910, 986, 1040, 1111, 1167, 1197, 1319, 1395, and 1454


    ICS Code

    ICS Number Code 77.060 (Corrosion of metals)

    UNSPSC Code

    UNSPSC Code 12141904(Oxygen O)


    DOI: 10.1520/G0094-92R98

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top