SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|22||$78.00||  ADD TO CART|
1.1 This practice covers the selection of methods and apparatus for the cleaning of materials and equipment intended for service in oxygen-enriched environments. Contamination problems encountered in the use of enriched air, mixtures of oxygen with other gases, or any other oxidizing gas may be solved by the same cleaning procedures applicable to most metallic and nonmetallic materials and equipment. Cleaning examples for some specific materials, components, and equipment, and the cleaning methods for particular applications, are described in detail in the appendix.
1.2 This guide does not include levels of cleanliness necessary for various applications and materials. These sections are currently under development and will be included in a future revision.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Federal, state and local safety and disposal regulations concerning the particular hazardous materials, reagents, operations and equipment being used should be reviewed by the user. The user is encouraged to obtain the Material Safety Data Sheets (MSDS) from the manufacturer for any material incorporated into a cleaning process. Specific cautions are given in Section 8.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A380 Practice for Cleaning, Descaling, and Passivation of Stainless Steel Parts, Equipment, and Systems
D1193 Specification for Reagent Water
E312 Practice for Description and Selection of Conditions for Photographing Specimens Using Analog (Film) Cameras and Digital Still Cameras (DSC)
E1235 Test Method for Gravimetric Determination of Nonvolatile Residue (NVR) in Environmentally Controlled Areas for Spacecraft
E2042 Practice for Cleaning and Maintaining Controlled Areas and Clean Rooms
F312 Test Methods for Microscopical Sizing and Counting Particles from Aerospace Fluids on Membrane Filters
F331 Test Method for Nonvolatile Residue of Solvent Extract from Aerospace Components (Using Flash Evaporator)
G63 Guide for Evaluating Nonmetallic Materials for Oxygen Service
G88 Guide for Designing Systems for Oxygen Service
G121 Practice for Preparation of Contaminated Test Coupons for the Evaluation of Cleaning Agents
G122 Test Method for Evaluating the Effectiveness of Cleaning Agents
G125 Test Method for Measuring Liquid and Solid Material Fire Limits in Gaseous Oxidants
G127 Guide for the Selection of Cleaning Agents for Oxygen Systems
G128 Guide for Control of Hazards and Risks in Oxygen Enriched Systems
G131 Practice for Cleaning of Materials and Components by Ultrasonic Techniques
G136 Practice for Determination of Soluble Residual Contaminants in Materials by Ultrasonic Extraction
G144 Test Method for Determination of Residual Contamination of Materials and Components by Total Carbon Analysis Using a High Temperature Combustion Analyzer
CGA DocumentsCGA Pamphlet G-4.4 Industrial Practices for Gaseous Oxygen Transmission and Distribution Piping Systems
SAE DocumentARP 598 The Determination of Particulate Contamination in Liquids by the Particle Count Method Available from SAE International (SAE), 400 Commonwealth Dr., Warrendale, PA 15096-0001, http://www.sae.org.
ICS Number Code 71.040.20 (Laboratory ware and related apparatus)
UNSPSC Code 12141904(Oxygen O)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM G93-96, Standard Practice for Cleaning Methods and Cleanliness Levels for Material and Equipment Used in Oxygen-Enriched Environments, ASTM International, West Conshohocken, PA, 1996, www.astm.orgBack to Top