ASTM G9-07

    Standard Test Method for Water Penetration into Pipeline Coatings


      Format Pages Price  
    PDF 4 $45.60   ADD TO CART


    1. Scope

    1.1 This method covers the determination of the apparent rate of depth of water penetration into insulating coatings applied to pipe.

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    G12 Test Method for Nondestructive Measurement of Film Thickness of Pipeline Coatings on Steel


    ICS Code

    ICS Number Code 23.040.01 (Pipeline components in general. Pipelines)

    UNSPSC Code

    UNSPSC Code 46181533(Protective coats)


    Referencing This Standard

    DOI: 10.1520/G0009-07

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM G9-07, Standard Test Method for Water Penetration into Pipeline Coatings, ASTM International, West Conshohocken, PA, 2007, www.astm.org

    Back to Top