ASTM G77-05e1

    Standard Test Method for Ranking Resistance of Materials to Sliding Wear Using Block-on-Ring Wear Test

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF Version 11 $57.60   ADD TO CART


    1. Scope

    1.1 This test method covers laboratory procedures for determining the resistance of materials to sliding wear. The test utilizes a block-on-ring friction and wear testing machine to rank pairs of materials according to their sliding wear characteristics under various conditions.

    1.2 An important attribute of this test is that it is very flexible. Any material that can be fabricated into, or applied to, blocks and rings can be tested. Thus, the potential materials combinations are endless. However, the interlaboratory testing has been limited to metals. In addition, the test can be run with various lubricants, liquids, or gaseous atmospheres, as desired, to simulate service conditions. Rotational speed and load can also be varied to better correspond to service requirements.

    1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. Wear test results are reported as the volume loss in cubic millimetres for both the block and ring. Materials of higher wear resistance will have lower volume loss.

    1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D2714 Test Method for Calibration and Operation of the Falex Block-on-Ring Friction and Wear Testing Machine

    E122 Practice for Calculating Sample Size to Estimate, With Specified Precision, the Average for a Characteristic of a Lot or Process

    E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

    G40 Terminology Relating to Wear and Erosion


    ICS Code

    ICS Number Code 19.060 (Mechanical testing); 77.040.10 (Mechanical testing of metals)

    UNSPSC Code

    UNSPSC Code 41114625(Wear testers)


    DOI: 10.1520/G0077-05E01

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top