ASTM G59-97(2009)

    Standard Test Method for Conducting Potentiodynamic Polarization Resistance Measurements


      Format Pages Price  
    PDF 4 $45.60   ADD TO CART


    1. Scope

    1.1 This test method covers an experimental procedure for polarization resistance measurements which can be used for the calibration of equipment and verification of experimental technique. The test method can provide reproducible corrosion potentials and potentiodynamic polarization resistance measurements.

    1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    G3 Practice for Conventions Applicable to Electrochemical Measurements in Corrosion Testing

    G5 Reference Test Method for Making Potentiodynamic Anodic Polarization Measurements

    G102 Practice for Calculation of Corrosion Rates and Related Information from Electrochemical Measurements


    ICS Code

    ICS Number Code 17.220.20 (Measurement of electrical and magnetic quantities)

    UNSPSC Code

    UNSPSC Code 41114604(Corrosion testers)


    Referencing This Standard

    DOI: 10.1520/G0059-97R09

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM G59-97(2009), Standard Test Method for Conducting Potentiodynamic Polarization Resistance Measurements, ASTM International, West Conshohocken, PA, 2009, www.astm.org

    Back to Top