ASTM G38-01(2007)

    Historical Standard: ASTM G38-01(2007) Standard Practice for Making and Using C-Ring Stress-Corrosion Test Specimens

    SUPERSEDED (see Active link, below)


    Buy Standard (PDF)
    8 pages
    $50.40

    Active (view current version of standard)


    ASTM G38

    1. Scope

    1.1 This practice covers the essential features of the design and machining, and procedures for stressing, exposing, and inspecting C-ring type of stress-corrosion test specimens. An analysis is given of the state and distribution of stress in the C-ring.

    1.2 Specific considerations relating to the sampling process and to the selection of appropriate test environments are outside the scope of this practice.

    1.3 The values stated in SI units are to be regarded as the standard; The values given in parentheses are for information only.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    NACE Document

    NACETM0177–96 Laboratory Testing of Metals for Resistance to Sulfide Stress Cracking and Stress Corrosion Cracking in H2S Environments Available from National Association of Corrosion Engineers (NACE), P.O. Box 218340, Houston, TX 77218-8340.


    ICS Code

    ICS Number Code 77.060 (Corrosion of metals)

    UNSPSC Code

    UNSPSC Code


    DOI: 10.1520/G0038-01R07

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top