ASTM G150-99(2004)

    Historical Standard: ASTM G150-99(2004) Standard Test Method for Electrochemical Critical Pitting Temperature Testing of Stainless Steels

    SUPERSEDED (see Active link, below)


    Buy Standard (PDF)
    13 pages
    $57.60

    Active (view current version of standard)


    ASTM G150

    1. Scope

    1.1 This test method covers a procedure for the evaluation of the resistance of stainless steel and related alloys to pitting corrosion based on the concept of the determination of a potential independent critical pitting temperature (CPT).

    1.2 This test methods applies to wrought and cast products including but not restricted to plate, sheet, tubing, bar, forgings, and welds, (see Note 0).

    Note 0

    Examples of CPT measurements on sheet, plate, tubing, and welded specimens for various stainless steels can be found in Ref. (). See the research report.

    1.3 The standard parameters recommended in this test method are suitable for characterizing the CPT of austenitic stainless steels and other related alloys with a corrosion resistance ranging from that corresponding to solution annealed UNS S31600 (Type 316 stainless steel) to solution annealed UNS S31254 (6 % Mo stainless steel).

    1.4 This test method may be extended to stainless steels and other alloys related to stainless steel that have a CPT outside the measurement range given by the standard parameters described in this test method. Appropriate test potential and solution must then be determined.

    1.5 The values stated in SI units are to be regarded as standard.

    1.6 his standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1193 Specification for Reagent Water

    D1293 Test Methods for pH of Water

    E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

    G1 Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens

    G3 Practice for Conventions Applicable to Electrochemical Measurements in Corrosion Testing

    G5 Reference Test Method for Making Potentiodynamic Anodic Polarization Measurements

    G46 Guide for Examination and Evaluation of Pitting Corrosion

    G107 Guide for Formats for Collection and Compilation of Corrosion Data for Metals for Computerized Database Input


    ICS Code

    ICS Number Code 77.140.20 (Steels of high quality)

    UNSPSC Code

    UNSPSC Code 41114604(Corrosion testers)


    DOI: 10.1520/G0150-99R04

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top