ASTM G121-98(2004)

    Standard Practice for Preparation of Contaminated Test Coupons for the Evaluation of Cleaning Agents

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF 4 $45.60   ADD TO CART


    1. Scope

    1.1 This practice describes the procedure for the preparation of single- and double-sided contaminated metallic test coupons for the evaluation of cleaning agents. It is applicable for the evaluation of cleaning agents proposed for the cleaning of oxygen-enriched systems and components. It also is applicable to other systems where contamination is a concern.

    1.2 Several classes of contaminants most likely to be found in oxygen-enriched systems and components are identified. However, if the user of this practice has identified contaminants not included in these classes, such identified contaminants may be substituted for the preparation of the test coupons.

    1.3 Preparation of nonmetallic substrates is not addressed, although similar methodology may be used. Solvent and cleaning agent compatibility with the nonmetallic substrate should be verified prior to the preparation of the test coupons. Typical nonmetallic materials utilized in oxygen systems are contained in Guide G 63.

    This practice may involve hazardous materials, operations, and equipment. This practice does not purport to address all of the safety concerns associated with its use. It is the responsibility of whomever uses this practice to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1193 Specification for Reagent Water

    E1235 Test Method for Gravimetric Determination of Nonvolatile Residue (NVR) in Environmentally Controlled Areas for Spacecraft

    F303 Practices for Sampling for Particles in Aerospace Fluids and Components

    F312 Test Methods for Microscopical Sizing and Counting Particles from Aerospace Fluids on Membrane Filters

    F324 Test Method for Nonvolatile Residue of Volatile Cleaning Solvents Using the Solvent Purity Meter

    F331 Test Method for Nonvolatile Residue of Solvent Extract from Aerospace Components (Using Flash Evaporator)

    G63 Guide for Evaluating Nonmetallic Materials for Oxygen Service

    G94 Guide for Evaluating Metals for Oxygen Service

    ANSI

    B46.1 Surface Texture (Surface Roughness, Waviness, and Lay)


    ICS Code

    ICS Number Code 71.100.40 (Surface active agents)

    UNSPSC Code

    UNSPSC Code 47132100(Cleaning kits)


    DOI: 10.1520/G0121-98R04

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top