Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM F559-95(2000)

Standard Test Method for Measuring Length of Road Test Courses Using a Fifth Wheel

Standard Test Method for Measuring Length of Road Test Courses Using a Fifth Wheel F0559-95R00 ASTM|F0559-95R00|en-US Standard Test Method for Measuring Length of Road Test Courses Using a Fifth Wheel Standard new BOS Vol. 09.02 Committee F09
$ 66.00 In stock

Scope

1.1 This test method covers the determination of the accurate length measurement of road courses used for testing all types of pneumatic tires on various associated vehicles.

1.2 This test method is intended for use on public highways or closed circuit test courses, or both, that cannot be measured practically by surveying techniques.

1.3 Use of this test method requires that the surface of the test course to be measured shall be sufficiently smooth to preclude bounce or hop of the fifth wheel, which will affect the accuracy of the measurement. The normal highway surface is adequate for this test method.

1.4 It is not the intent or scope of this test method to encompass distance measurements of test courses whose surfaces are irregular, broken up, jagged, etc., such as rock courses, Belgian block, "rumble" surfaces, etc. Snow- and ice-covered surfaces also are excluded.

1.5 The values stated in either inch-pound or SI units are to be regarded separately as standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 09.02
Developed by Subcommittee: F09.10
Pages: 2
DOI: 10.1520/F0559-95R00
ICS Code: 43.180