Standard Historical Last Updated: Dec 17, 2012 Track Document
ASTM F2508-11

Standard Practice for Validation and Calibration of Walkway Tribometers Using Reference Surfaces

Standard Practice for Validation and Calibration of Walkway Tribometers Using Reference Surfaces F2508-11 ASTM|F2508-11|en-US Standard Practice for Validation and Calibration of Walkway Tribometers Using Reference Surfaces Standard new BOS Vol. 15.07 Committee F13
$ 75.00 In stock

Significance and Use

To be meaningful, walkway tribometer results must correlate the slip characteristics of a surface or contaminant, or both, to the actual propensity for human slips. To achieve this goal, walkway tribometer models must be validated against a standard with relevance to human ambulation.

This practice prescribes a series of reference surfaces with known relative slip potential ranging from very high to low (as defined by laboratory conditions only) upon which walkway tribometer models can be validated. The relative slip potential of each reference surface was established from human subject walking trials.

The following should be considered in applying the validation and calibration obtained by this practice:

The scientific study upon which the validation process is based was conducted with a select population of young adults (mean age 26 years) who were free from gait deviations while walking in a straight path on a level surface with a mean walking velocity of 2.18 m/s. This walking velocity is faster than the average walking velocity for the general population which includes a much wider age range with greater variability; thus, the study sample population of pedestrians and conditions is not representative of the larger general population of pedestrians.

All subjects walked in Oxford-style shoes whose soles were constructed of smooth styrene butadiene rubber (SBR) with 75A Shore hardness. The shoe style and sole material is not representative of all combinations available in the marketplace.

The reference surfaces defined in this practice are not representative of all walkway surfaces. The outcome of the validation practice reflects performance on the type of reference surfaces and surface conditions defined in this practice only. Validation and calibration of a walkway tribometer as defined by this practice does not imply validation and calibration under all combinations of test foot materials and walkway surfaces.

The validation and calibration procedure defined by this practice is not intended to establish a safe threshold value for any walkway surface.

Scope

1.1 This practice is intended to establish the parameters for validation and calibration of walkway tribometers.

1.2 This practice provides a walkway tribometer supplier with a procedure and suite of reference surfaces to validate his walkway tribometer by properly ranking and differentiating the surfaces.

1.3 This practice provides the user of a walkway tribometer with a procedure and suite of reference surfaces to test calibration of his instrument.

1.4 This practice describes the necessary materials, specifications, and the cleaning process for reference materials, as well as the requirements for the validation of a suppliers walkway tribometer and calibration of a users walkway tribometer.

1.5 This practice applies to walkway tribometers without reference to the nature of the scale of the readings produced by them. The scale used in the reports of validation and calibration must be the same, and are to be those of the instrument or defined for the instrument.

1.6 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only and are not considered standard.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.07
Developed by Subcommittee: F13.10
Pages: 5
DOI: 10.1520/F2508-11
ICS Code: 17.040.20; 93.080.10