Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM F2226-03

Standard Practice for Determining the Adhesion of Prints and Laminating Films

Standard Practice for Determining the Adhesion of Prints and Laminating Films F2226-03 ASTM|F2226-03|en-US Standard Practice for Determining the Adhesion of Prints and Laminating Films Standard new BOS Vol. 15.11 Committee F05
$ 75.00 In stock

Scope

1.1 This practice covers procedures for printing a document, applying a laminating film and subsequently delaminating. The laminate film is used for encapsulating and mounting prints to preserve them in office and outdoor environments.

1.2 This practice describes procedures for determining the adhesion strength of lamination film when it is applied to black and white and color prints produced by printers, copiers and other reprographic devices.

1.3 This practice can be used to test different laminates with a given set of inks and media or it can be used to evaluate inks and media with a given laminate.

1.4 This practice specifies size of specimens and defines conditions for measurement of peel adhesion at a 180 angle and delamination speed.

1.5 This practice is applicable to constructions where the substrate surface is subject to failure under peel conditions.

1.6 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.11
Developed by Subcommittee: F05.03
Pages: 6
DOI: 10.1520/F2226-03
ICS Code: 37.100.20