Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM F180-94(2005)

Standard Test Method for Density of Fine Wire and Ribbon Wire for Electronic Devices

Standard Test Method for Density of Fine Wire and Ribbon Wire for Electronic Devices F0180-94R05 ASTM|F0180-94R05|en-US Standard Test Method for Density of Fine Wire and Ribbon Wire for Electronic Devices Standard new BOS Vol. 10.04 Committee F01
$ 66.00 In stock

Abstract

This test method establishes the standard procedures and calculations used (including precision and biases) for determining, to an accuracy of 1.0 %, the density of fine wires and ribbon wires that are used in electronic devices. This test method requires the use of the following apparatus: chemical balance, micrometer, standard volume cylinder, thermometer, vacuum pump and desiccator, and hook and cradle suspended by a fine wire.

Scope

1.1 This test method covers the determination of, to an accuracy of 1.0%, the density of fine wires ranging from 0.25 to 0.02 mm (0.010 to 0.001 in.) in diameter, or ribbons of similar thicknesses, for electronic devices.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 4.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 10.04
Developed by Subcommittee: F01.03
Pages: 3
DOI: 10.1520/F0180-94R05
ICS Code: 29.060.10