ASTM F1790-97

    Standard Test Method for Measuring Cut Resistance of Materials Used in Protective Clothing

      Format Pages Price  
    PDF 6 $51.60   ADD TO CART

    1. Scope

    1.1 This test method covers the measurement of the cut resistance of a material when mounted on a mandrel and subjected to a cutting edge under a specified load.

    1.1.1 This procedure is not valid for high-porosity materials which allow cutting edge contact with the mounting surface prior to cutting, or for materials greater than 3 mm in thickness.

    1.2 The values stated in SI units or in other units shall be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D123 Terminology Relating to Textiles

    D1776 Practice for Conditioning and Testing Textiles

    F1494 Terminology Relating to Protective Clothing

    ASTM Adjunct

    Cut Test Video Demonstration Available from ASTM Headquarters. Request Adjunct No. .

    ICS Code

    ICS Number Code 13.340.10 (Protective clothing)

    UNSPSC Code

    UNSPSC Code 53100000(Clothing)

    Referencing This Standard

    DOI: 10.1520/F1790-97

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM F1790-97, Standard Test Method for Measuring Cut Resistance of Materials Used in Protective Clothing, ASTM International, West Conshohocken, PA, 1997,

    Back to Top