Standard Historical Last Updated: Aug 29, 2012 Track Document
ASTM F1374-92(2005)

Standard Test Method for Ionic/Organic Extractables of Internal Surfaces-IC/GC/FTIR for Gas Distribution System Components

Standard Test Method for Ionic/Organic Extractables of Internal Surfaces-IC/GC/FTIR for Gas Distribution System Components F1374-92R05 ASTM|F1374-92R05|en-US Standard Test Method for Ionic/Organic Extractables of Internal Surfaces-IC/GC/FTIR for Gas Distribution System Components Standard new BOS Vol. 10.04 Committee F01
$ 75.00 In stock

Significance and Use

The purpose of this test method is to define a procedure for testing electropolished stainless steel components being considered for installation into a high-purity gas distribution system. Application of this test method is expected to yield comparable data among components tested for the purposes of qualification for this installation.


FIG. 1 Ionic/Organic Contribution Data Table Illustration


FIG. 2 Ionic/Organic Contribution Data Table Illustration

Scope

1.1 This test method establishes a procedure for testing components used in ultra-high-purity gas distribution systems for ionic and organic surface residues.

1.2 This test method applies to in-line components containing electronics grade materials in the gaseous form.

1.3 Limitations:

1.3.1 This test method is limited by the sensitivity of the detection instruments and by the available levels of purity in extracting solvents. While the ion and gas chromatographic methods are quantitative, the Fourier transform infrared spectroscopy (FTIR) method can be used as either a qualitative or a quantitative tool. In addition, the gas chromatography (GC) and FTIR methods are used to detect hydrocarbons and halogenated substances that remain as residues on component internal surfaces. This eliminates those materials with high vapor pressures, which are analyzed per the total hydrocarbons test, from this test method.

1.3.2 This test method is intended for use by operators who understand the use of the apparatus at a level equivalent to twelve months of experience.

1.4 The values stated in SI units are to be regarded as the standards. The inch-pound units given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 6.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 10.04
Developed by Subcommittee: F01.10
Pages: 5
DOI: 10.1520/F1374-92R05
ICS Code: 17.040.20