ASTM F1233-98

    Standard Test Method for Security Glazing Materials And Systems


      Format Pages Price  
    PDF 12 $58.80   ADD TO CART


    1. Scope

    1.1 This test method sets forth procedures whose purpose is limited to the evaluation of the resistance of security glazing materials and systems against the following threats:

    1.1.1 Ballistic Impact ,

    1.1.2 Blunt Tool Impacts ,

    1.1.3 Sharp Tool Impacts ,

    1.1.4 Thermal Stress , and

    1.1.5 Chemical Deterioration.

    Note 1-Specifically exempted from this test method are the use of power (motor or engine-driven) tools or devices, explosives, military ordinance (excepting small arms) and tools, processes or devices requiring more than two persons to transport and operate.

    1.2 The values stated in inch-pounds are to be regarded as the standard. The values given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific warning statement, see Note 2.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A36/A36M Specification for Carbon Structural Steel

    A53/A53M Specification for Pipe, Steel, Black and Hot-Dipped, Zinc-Coated, Welded and Seamless

    A574 Specification for Alloy Steel Socket-Head Cap Screws

    F1029 Guide for Selection of Physical Security Measures for a Facility


    ICS Code

    ICS Number Code 13.310 (Protection against crime); 81.040.20 (Glass in building)

    UNSPSC Code

    UNSPSC Code 46151600(Security and control equipment)


    Referencing This Standard

    DOI: 10.1520/F1233-98

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM F1233-98, Standard Test Method for Security Glazing Materials And Systems, ASTM International, West Conshohocken, PA, 1998, www.astm.org

    Back to Top