ASTM F1199-88(1998)

    Standard Specification for Cast (All Temperatures and Pressures) and Welded Pipe Line Strainers (150 psig and 150°F Maximum)

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF Version 3 $44.40   ADD TO CART


    1. Scope

    1.1 This standard covers all cast strainers and welded strainers in services up to 150 psig and 150°F (1 MPa and 65°C). For welded strainers used in services above 150 psig and 150°F, see Specification F1200.

    1.2 This standard provides the minimum requirements for the design, fabrication, rating, marking, and testing of cast and welded pipe line strainers for services above 0°F (-18°C).

    1.3 Strainers manufactured to this specification are acceptable for use in the marine environment.

    1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

    1.5 The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASME Standard

    ASMEBoilerandPressur Division 1, PressureVessels

    ASTM Standards

    F1200 Specification for Fabricated (Welded) Pipe Line Strainers (Above 150 psig and 150F)

    ANSI Standards

    B31.1 Power Piping

    MSS Standards

    SP-63 High Strength Wrought Welding Fittings


    ICS Code

    ICS Number Code 23.040.01 (Pipeline components in general. Pipelines)

    UNSPSC Code

    UNSPSC Code 40170000(Pipe piping and pipe fittings)


    DOI: 10.1520/F1199-88R98

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top