Standard Historical Last Updated: Jan 11, 2012 Track Document
ASTM F1150-06

Standard Specification for Commercial Food Waste Pulper and Waterpress Assembly

Standard Specification for Commercial Food Waste Pulper and Waterpress Assembly F1150-06 ASTM|F1150-06|en-US Standard Specification for Commercial Food Waste Pulper and Waterpress Assembly Standard new BOS Vol. 15.12 Committee F26
$ 75.00 In stock

Abstract

This specification establishes the material, design, and performance requirements pertinent to the construction of commercial pulping and waterpress assemblies that are intended for grinding food scraps, paper, cardboard, and disposable plastic food-service ware. Unless otherwise specified, materials used to fabricate pulpers and waterpresses may include corrosion-resistant steel and other corrosion-resisting materials, abrasion-resistant cast iron, austenitic gray iron, copper tube, brass pipe, alloy steel, black and galvanized pipe, gaskets and seals, perforated metal, stainless steel pipe, plastic piping and fitting, and austenitic gray iron pipe fitting. Assembled pulpers and waterpresses shall meet operational, electrical, lubrication, finish, and performance requirements, and should function satisfactorily as specified.

Scope

1.1 This specification covers commercial pulping and waterpress assemblies intended for grinding of food scraps, paper, cardboard, and disposable plastic food-service ware.

1.2 The values as stated in inch-pound units are to be regarded as the standard. The values in parentheses are given for information only.

1.3 The following safety hazards caveat pertains only to the test method portion, Section , of this specification:

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.12
Developed by Subcommittee: F26.01
Pages: 5
DOI: 10.1520/F1150-06
ICS Code: 13.030.40; 97.030